Notifications
Clear all
RetireeJay
RetireeJay
Group: Registered
Joined: 2018/02/13
Reputable Member
5
Keeping your filament really dry seems to help with stringin...

In forum How do I print this? (Printing help)

4 years ago
I should have said that depending on the filament and the pr...

In forum Assembly and first prints troubleshooting

5 years ago
I print almost exclusively with PETG. I found that I could ...

In forum Assembly and first prints troubleshooting

5 years ago
My first printer was a Printrbot which used 3mm filament. T...

In forum Print tips (Archive)

5 years ago
Can you post a larger picture? I can't see any "interruptio...

In forum PrusaSlicer

5 years ago
It's worth noting that the temperature of a stepper motor is...

In forum General discussion, announcements and releases

5 years ago
I don't have Fusion 360 either. The bug does not depend on ...

In forum Hardware, firmware and software help

5 years ago
OK, following your workflow I was able to duplicate your res...

In forum Hardware, firmware and software help

5 years ago
I'm not saying that anyone should be able to edit posts! On...

In forum General discussion, announcements and releases

5 years ago
Flywheels? Plastic is not very dense, so if you are worried...

In forum General discussion, announcements and releases

5 years ago
Honestly, is there any reason for an Edit time-out? In the ...

In forum General discussion, announcements and releases

5 years ago
Great Franglais! 🤣 And glad to hear that your printer is OK...

In forum Discussion générale, annonces et nouveautés

5 years ago
Can we PLEASE PLEASE PLEASE PLEASE increase the time allowed...

In forum General discussion, announcements and releases

5 years ago
And according to my French - French dictionary, "descendre" ...

In forum Discussion générale, annonces et nouveautés

5 years ago
The OP is just using common French abbreviations; we do the ...

In forum Discussion générale, annonces et nouveautés

5 years ago
These same principles would apply even to a vertical surface...

In forum Hardware, firmware and software help

5 years ago
Yes, I'm using the MK3S extruder. Although previously I was...

In forum Awesome prints (Hall Of Fame)

5 years ago
Great work, metacollin! I would add that I think increasing...

In forum General discussion, announcements and releases

5 years ago
So, after you re-size your test cube in Fusion 360 and save ...

In forum Hardware, firmware and software help

5 years ago
By the way, canquest, you may have noticed that people are a...

In forum General discussion, announcements and releases

5 years ago
Page 1 / 13
Share: