RedDawg
RedDawg
Group: Registered
Joined: 2018/01/07
Estimable Member
4
Controlled/Step-wise Mesh bed Leveling

In forum General software discussion

1 month ago
On the GitHub thread (), "rtyr" posted an illustration showi...

In forum Hardware, firmware and software help

1 month ago
This is a guess, it is only a guess. Had it been an actual r...

In forum General discussion, announcements and releases

1 month ago
As always, a picture would be extremely helpful. Are you try...

In forum General discussion, announcements and releases

1 month ago
Got a comment already: Looking into it now. n8bot commented ...

In forum Hardware, firmware and software help

1 month ago
OK, I submitted a New Feature request to GitHub to which the...

In forum Hardware, firmware and software help

1 month ago
@neophyl I have worked with Cura, but not recently, and neve...

In forum Hardware, firmware and software help

1 month ago
@neophyl I considered that approach, that is, sanding away a...

In forum Hardware, firmware and software help

1 month ago
@joe-w10 I think this limitation is also responsible for the...

In forum Hardware, firmware and software help

1 month ago
I think you have to make a distinction between printers you ...

In forum General discussion, announcements and releases

1 month ago
@covertpluto My point is that, for the bottom layer, it does...

In forum General discussion, announcements and releases

1 month ago
As mentioned in a different posting, I restore the mechanism...

In forum General discussion, announcements and releases

2 months ago
Bottom Layer Fill Patterns

In forum General discussion, announcements and releases

2 months ago
Unless you need it immediately, why not just order it?

In forum General discussion, announcements and releases

2 months ago
Here's another one I have posited before but should have inc...

In forum General discussion, announcements and releases

2 months ago
Agreeing with everyone above, particularly not letting an un...

In forum General discussion, announcements and releases

2 months ago
Is there any confirmation on this conjecture? I'm also curio...

In forum General discussion, announcements and releases

2 months ago
@peter-c20 I described raft selection incorrectly. Just set ...

In forum General discussion, announcements and releases

2 months ago
Isn't that just a "raft"? Check the Support tab to see if Ra...

In forum General discussion, announcements and releases

2 months ago
@shacharweis Added my comment before seeing your follow-up. ...

In forum General discussion, announcements and releases

2 months ago
Page 1 / 6
Share:

Please Login or Register