|
I have mine assembled as of yesterday but haven't tried usin... In forum General discussion, announcements and releases |
6 years ago |
|
I also need to engineer a solution here as the Prusa solutio... In forum General discussion, announcements and releases |
6 years ago |
|
Extruder motor melted part of my extruder..
I now have ... In forum Hardware, firmware and software help |
6 years ago |
|
That is bizarre. If that was a duplicate part printed at th... In forum General discussion, announcements and releases |
6 years ago |
|
That should not happen at all... are you sure you have the s... In forum General discussion, announcements and releases |
6 years ago |
|
I figured out my extruding problem. The long screws that ho... In forum General discussion, announcements and releases |
6 years ago |
|
No.
Print quality with MK2S was much better. I can't even ... In forum General discussion, announcements and releases |
6 years ago |
|
When printing my upgrade I had to print in the colors of my ... In forum Others (Archive) |
6 years ago |
|
CorrosionX is a great option for preventing rust as well. I... In forum Others (Archive) |
6 years ago |
|
The disadvantage of Bondtech gears In forum Others (Archive) |
6 years ago |
|
@cameron.c3
Start with the downloaded settings from S3D. F... In forum General discussion, announcements and releases |
6 years ago |
|
Regarding lubrication, the Prusa bearings have some oil in t... In forum Others (Archive) |
6 years ago |
|
I had replaced some of the bearings on my MK2 just to try to... In forum Others (Archive) |
6 years ago |
|
Bearings In forum Others (Archive) |
6 years ago |
|
Does anyone know if the upgrades started shipping yet? They... In forum General discussion, announcements and releases |
6 years ago |
|
Having gone down this road, let me simply say: Don't.
Use... In forum Others (Archive) |
6 years ago |
|
Thanks for the suggestions. I wound up redesigning the part... In forum Print tips (Archive) |
7 years ago |
|
This is only part of the whole part.. I offset the part dow... In forum Print tips (Archive) |
7 years ago |
|
ABS @ 0.1mm is sagging? In forum Print tips (Archive) |
7 years ago |
