randolph.l
randolph.l
Group: Registered
Joined: 2018/09/14
Honorable Member
1
I use florist soft iron arrangement wire in the smallest siz...

In forum Hardware, firmware and software help

10 months ago
measure the height of the bed spacers one of mine was .5mm s...

In forum Assembly and first prints troubleshooting

10 months ago
What Tim said :geek: .... also congratulations you have done...

In forum Assembly and first prints troubleshooting

10 months ago
I use my Prusa Textured plate with PETG and do not use any b...

In forum Hardware, firmware and software help

10 months ago
Maybe not one connector to rule them all, but I’d like conne...

In forum General discussion, announcements and releases

10 months ago
I use Gyroid infill most of time but I print mostly PETG

In forum General discussion, announcements and releases

10 months ago
set your live z with this method it is far better than the ...

In forum How do I print this? (Printing help)

10 months ago
don't expect quick action from prusa with email their suppor...

In forum Hardware, firmware and software help

10 months ago
Henry, take vintagePC's advice and set your live z with this...

In forum Assembly and first prints troubleshooting

10 months ago
well done getting the firmware zig zag live z to work for yo...

In forum Assembly and first prints troubleshooting

10 months ago
contact prusa online chat system 24/7 support they have folk...

In forum Assembly and first prints troubleshooting

10 months ago
I have had very good results with the Prusa clear PETG ...

In forum Awesome prints (Hall Of Fame)

10 months ago
"25% Nitromethane, 55% Methanol, 20% Oil (100% castor or up ...

In forum General discussion, announcements and releases

10 months ago
Weld on #16 or Loctite Super Glue Gel full details here ...

In forum Assembly and first prints troubleshooting

10 months ago
given the fingerprints on your plate, the best prep for your...

In forum How do I print this? (Printing help)

10 months ago
contact prusa online chat system 24/7 support log into your ...

In forum Assembly and first prints troubleshooting

10 months ago
the best prep for your bed is to wash it with warm water and...

In forum Assembly and first prints troubleshooting

10 months ago
this is my full detail version of Joan's instructions For t...

In forum How do I print this? (Printing help)

10 months ago
take a look at nice design but it returns a not found if ...

In forum General discussion, announcements and releases

10 months ago
After testing many beds, I need to find a life Z test print ...

In forum General discussion, announcements and releases

10 months ago
Page 1 / 37
Share:

Please Login or Register