|
The extruder motor will make a distinct loud click every now... In forum Hardware, firmware and software help |
3 years ago |
|
@freelancercal Absolutely no problem with reviving older thr... In forum Hardware, firmware and software help |
3 years ago |
|
@pcweber The grit I'm fine with, but the shroud is sagging s... In forum Hardware, firmware and software help |
4 years ago |
|
@chrisaaronmurphy Please read the post. That is not a sag, i... In forum Hardware, firmware and software help |
4 years ago |
|
@kenatno10 I do believe that is a problem with the newer mod... In forum Hardware, firmware and software help |
4 years ago |
|
@pcweber Now the previous shroud was a snug fit that had no ... In forum Hardware, firmware and software help |
4 years ago |
|
@kenatno10 Yes I printed the newest versions to touch up aft... In forum Hardware, firmware and software help |
4 years ago |
|
New fanshroud sits loose In forum Hardware, firmware and software help |
4 years ago |
|
MMU2 single will add the gcode commands "Tx", "Tc" and last ... In forum Hardware, firmware and software help |
5 years ago |
|
Ok! So I have no idea how this works, nor what I'm doing her... In forum Hardware, firmware and software help |
5 years ago |
|
The first is that I can't get the printer to load any filame... In forum Hardware, firmware and software help |
5 years ago |
|
Like this? 😀 In forum Hardware, firmware and software help |
5 years ago |
|
Haha thx 😀 Ye I did apply good force before torque, and I c... In forum Hardware, firmware and software help |
5 years ago |
|
There is a lot that can be wrong here, but first off all I n... In forum Hardware, firmware and software help |
5 years ago |
|
Unfortunately that is something I have done, and I dont thin... In forum Hardware, firmware and software help |
5 years ago |
|
Bondtech lock-screw unscrews In forum Hardware, firmware and software help |
5 years ago |
|
RE: Is the firmware in the MK3S+MMU2S different from just MK... In forum Hardware, firmware and software help |
5 years ago |
|
According to the file hash they're exactly the same. So no, ... In forum Hardware, firmware and software help |
5 years ago |
|
So apparently this is a know software issue that has been so... In forum Hardware, firmware and software help |
5 years ago |
|
Failure mode failing itself In forum Hardware, firmware and software help |
5 years ago |
