Activity
 
Notifications
Clear all
PJR
PJR
Group: Moderator
Joined: 2015/06/01
Title: Antient Member Moderator
You need to remove the hot end from the heat sink, remove PT...

In forum Assembly and first prints troubleshooting

4 years ago
As the probe does not have temperature sensing, you need to ...

In forum Hardware, firmware and software help

4 years ago
Mine does similar, but not quite as bad as you describe. I t...

In forum General discussion, announcements and releases

4 years ago
To check you need to remove the PTFE tube and look down into...

In forum Assembly and first prints troubleshooting

4 years ago
If you have short PTFE tube, then the heat break threads wil...

In forum Assembly and first prints troubleshooting

4 years ago
Cold pull at 105 degrees 😉 Peter

In forum General discussion, announcements and releases

4 years ago
You really do need to make sure there is no plastic in the h...

In forum General discussion, announcements and releases

4 years ago
Most likely one of two things: Blocked nozzle - partial bloc...

In forum General discussion, announcements and releases

4 years ago
I printed some floats for a garden fountain using PETG Prusa...

In forum How do I print this? (Printing help)

4 years ago
@olef Olives should be available via chat. If you ask them ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
You do need to be careful with your extrusion settings and a...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
Temperature variance can cause this. Even just a few degree...

In forum Assembly and first prints troubleshooting

4 years ago
From the guy who created the Mini profiles within PS: Linear...

In forum Hardware, firmware and software help

4 years ago
FWIW, I have been advised that Linear Advance is not great w...

In forum Hardware, firmware and software help

4 years ago
The MINDa does not have temperature compensation (cost const...

In forum Hardware, firmware and software help

4 years ago
You should not cut the PTFE tubing. Remove the Bowden connec...

In forum Assembly and first prints troubleshooting

4 years ago
Just a couple of things you could check:The u-bolts holding ...

In forum Assembly and first prints troubleshooting

4 years ago
This is a slicer setting. The temperature for probing the be...

In forum Assembly and first prints troubleshooting

4 years ago
This is already on the "ToDo" list. Should be in one of the...

In forum Hardware, firmware and software help

4 years ago
Acetone does make the PEI brittle, but it also does increase...

In forum Assembly and first prints troubleshooting

4 years ago
Page 2 / 281
Share: