|
Maximum non-printing X/Y speed is 400mm/s. And with any prin... In forum General discussion, announcements and releases |
1 year ago |
|
Honestly, if I were in your position, I would just take the ... In forum General discussion, announcements and releases |
1 year ago |
|
Testers are receiving "fully-built" versions which only requ... In forum Assembly and first prints troubleshooting |
1 year ago |
|
One thing you can try...
Let the printer cool down and loo... In forum Hardware, firmware and software help |
1 year ago |
|
Melt volume... The V6 has a melt volume of about 11.5 mm^3/s... In forum General discussion, announcements and releases |
1 year ago |
|
I have passed this on (upwards) requesting that it be looked... In forum General discussion, announcements and releases |
1 year ago |
|
The steppers in the XL are much bigger than the Mk3/Mk4 and ... In forum General discussion, announcements and releases |
1 year ago |
|
Personally,I believe that any performance increase will be s... In forum General discussion, announcements and releases |
1 year ago |
|
Thanks for your kind comment 🙂 Yes, it arrived last Christ... In forum General discussion, announcements and releases |
1 year ago |
|
Personally, I am very happy with the beta printer (note: thi... In forum General discussion, announcements and releases |
1 year ago |
|
For reference, my single head beta XL machine draws up to 49... In forum General discussion, announcements and releases |
1 year ago |
|
You can always replace the PEI sheet:/p> Peter In forum General discussion, announcements and releases |
2 years ago |
|
Sounds as though you have the Mk3+MMU2? This is the Mk2+MMU... In forum Hardware, firmware and software help |
2 years ago |
|
I had this exact issue recently on the oldest of my Mk2+MMU.... In forum General discussion, announcements and releases |
2 years ago |
|
You can buy a new PEI sheet here:/p> Replacement is a PITA, ... In forum Hardware, firmware and software help |
2 years ago |
|
I don't think this will be "fixed" and honestly I would not ... In forum Assembly and first prints troubleshooting |
4 years ago |
|
I don't know for sure, but I don't think there is any other ... In forum General discussion, announcements and releases |
4 years ago |
|
Flash memory is used for firmware settings. It is nothing l... In forum General discussion, announcements and releases |
4 years ago |
|
I revised my method as I didn't really have much luck doing ... In forum Assembly and first prints troubleshooting |
4 years ago |
|
Most likely, you have some plastic under the PTFE that is ca... In forum General discussion, announcements and releases |
4 years ago |
