Activity
 
Notifications
Clear all
PJR
PJR
Group: Moderator
Joined: 2015/06/01
Title: Antient Member Moderator
Maximum non-printing X/Y speed is 400mm/s. And with any prin...

In forum General discussion, announcements and releases

12 months ago
Honestly, if I were in your position, I would just take the ...

In forum General discussion, announcements and releases

12 months ago
Testers are receiving "fully-built" versions which only requ...

In forum Assembly and first prints troubleshooting

12 months ago
One thing you can try... Let the printer cool down and loo...

In forum Hardware, firmware and software help

12 months ago
Melt volume... The V6 has a melt volume of about 11.5 mm^3/s...

In forum General discussion, announcements and releases

12 months ago
I have passed this on (upwards) requesting that it be looked...

In forum General discussion, announcements and releases

1 year ago
The steppers in the XL are much bigger than the Mk3/Mk4 and ...

In forum General discussion, announcements and releases

1 year ago
Personally,I believe that any performance increase will be s...

In forum General discussion, announcements and releases

1 year ago
Thanks for your kind comment 🙂 Yes, it arrived last Christ...

In forum General discussion, announcements and releases

1 year ago
Personally, I am very happy with the beta printer (note: thi...

In forum General discussion, announcements and releases

1 year ago
For reference, my single head beta XL machine draws up to 49...

In forum General discussion, announcements and releases

1 year ago
You can always replace the PEI sheet:/p> Peter

In forum General discussion, announcements and releases

2 years ago
Sounds as though you have the Mk3+MMU2? This is the Mk2+MMU...

In forum Hardware, firmware and software help

2 years ago
I had this exact issue recently on the oldest of my Mk2+MMU....

In forum General discussion, announcements and releases

2 years ago
You can buy a new PEI sheet here:/p> Replacement is a PITA, ...

In forum Hardware, firmware and software help

2 years ago
I don't think this will be "fixed" and honestly I would not ...

In forum Assembly and first prints troubleshooting

4 years ago
I don't know for sure, but I don't think there is any other ...

In forum General discussion, announcements and releases

4 years ago
Flash memory is used for firmware settings. It is nothing l...

In forum General discussion, announcements and releases

4 years ago
I revised my method as I didn't really have much luck doing ...

In forum Assembly and first prints troubleshooting

4 years ago
Most likely, you have some plastic under the PTFE that is ca...

In forum General discussion, announcements and releases

4 years ago
Page 1 / 281
Share: