Activity
 
PJR
PJR
Group: Moderator
Joined: 2015/06/01
Title: Antient Member Moderator
I don't think this will be "fixed" and honestly I would not ...

In forum Assembly and first prints troubleshooting

1 month ago
I don't know for sure, but I don't think there is any other ...

In forum General discussion, announcements and releases

1 month ago
Flash memory is used for firmware settings. It is nothing l...

In forum General discussion, announcements and releases

1 month ago
I revised my method as I didn't really have much luck doing ...

In forum Assembly and first prints troubleshooting

1 month ago
Most likely, you have some plastic under the PTFE that is ca...

In forum General discussion, announcements and releases

2 months ago
You need to remove the hot end from the heat sink, remove PT...

In forum Assembly and first prints troubleshooting

2 months ago
As the probe does not have temperature sensing, you need to ...

In forum General discussion, announcements and releases

2 months ago
Mine does similar, but not quite as bad as you describe. I t...

In forum General discussion, announcements and releases

2 months ago
To check you need to remove the PTFE tube and look down into...

In forum Assembly and first prints troubleshooting

2 months ago
If you have short PTFE tube, then the heat break threads wil...

In forum Assembly and first prints troubleshooting

2 months ago
Cold pull at 105 degrees 😉 Peter

In forum General discussion, announcements and releases

2 months ago
You really do need to make sure there is no plastic in the h...

In forum General discussion, announcements and releases

2 months ago
Most likely one of two things: Blocked nozzle - partial bloc...

In forum General discussion, announcements and releases

2 months ago
I printed some floats for a garden fountain using PETG Prusa...

In forum How do I print this? (Printing help)

2 months ago
@olef Olives should be available via chat. If you ask them ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
You do need to be careful with your extrusion settings and a...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
Temperature variance can cause this. Even just a few degree...

In forum Assembly and first prints troubleshooting

3 months ago
From the guy who created the Mini profiles within PS: Peter

In forum Hardware, firmware and software help

3 months ago
FWIW, I have been advised that Linear Advance is not great w...

In forum Hardware, firmware and software help

3 months ago
The MINDa does not have temperature compensation (cost const...

In forum Hardware, firmware and software help

3 months ago
Page 1 / 280
Share:

Please Login or Register