peter.m26
peter.m26
Group: Registered
Joined: 2018/01/02
Honorable Member
1
Does the pinda sensor move on the circle on the bed? Does yo...

In forum Assembly and first prints troubleshooting

21 mins ago
The holes, close the last 2 or 3 layers of the holes, then ...

In forum How do I print this? (Printing help)

28 mins ago
You give no info?????? The test you let see is a difficult o...

In forum Hardware, firmware and software help

1 hour ago
Make a picture so we can see if model is not flat. Possible ...

In forum How do I print this? (Printing help)

1 hour ago
-Clean nozzle with copper wire brush if needed, so filament ...

In forum General discussion, announcements and releases

1 hour ago
If possible , the best way is to blow it to the outside air....

In forum General discussion, announcements and releases

2 hours ago
Fan mount I printed with ABS.

In forum Assembly and first prints troubleshooting

2 days ago
@martin-d17 Make a mark on your filament 0mm , mark 100mm an...

In forum Assembly and first prints troubleshooting

2 days ago
@bruce-h7 yes, that can get damaged difficult to repair or i...

In forum General discussion, announcements and releases

3 days ago
Give as much info you know, we know nothing of what you are ...

In forum How do I print this? (Printing help)

3 days ago
Print fan duck in abs, a few extra. The 2 fans on the extrud...

In forum General discussion, announcements and releases

3 days ago
The object is small. The ring under de egg is to thin and th...

In forum How do I print this? (Printing help)

4 days ago
Replacement parts you need always, check if you need more pa...

In forum Hardware, firmware and software help

4 days ago
Keep the firmware and prusaslicer version together, update b...

In forum Hardware, firmware and software help

4 days ago
If layers are to thin to print, you get empty space. You cou...

In forum How do I print this? (Printing help)

4 days ago
The first layer is also not sticking enough to the bed, clea...

In forum How do I print this? (Printing help)

4 days ago
First layer is to low. Every new print you have to check the...

In forum How do I print this? (Printing help)

4 days ago
Pictures of model and first layer please?

In forum Assembly and first prints troubleshooting

4 days ago
I had a print that in middle of the print, changed from mat ...

In forum General discussion, announcements and releases

4 days ago
If printing works you can leave it how it is, if have none f...

In forum Hardware, firmware and software help

4 days ago
Page 1 / 26
Share:

Please Login or Register