Notifications
Clear all
pcweber
pcweber
Skupina: PrusaLink-beta
Přidal se: 2019/12/16
Název: Member
How not to store filament

In forum General discussion, announcements and releases

před 1 year
Check out the FINDA. All lights may mean that the sensor is ...

In forum Hardware, firmware and software help

před 2 years
Depends on your experience with the printer, it took me two ...

In forum General discussion, announcements and releases

před 2 years
Nail down the first layer, using a 0.4 mm nozzle the printed...

In forum General discussion, announcements and releases

před 2 years
Try this -

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 2 years
I suppose that one could save, where I am almost certain tha...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 2 years
Raspian is a Linux flavor; therefore, the base system where ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 2 years
Although it's been awhile since I had to replace my shroud, ...

In forum General discussion, announcements and releases

před 2 years
Follow the print instructions from Prusa, the shroud should ...

In forum General discussion, announcements and releases

před 2 years
I suppose that you're right, perhaps my troubles with the Co...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 2 years
I had a lot of filament getting stuck on the way to the nozz...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 2 years
I used the copperhead for awhile, had some troubles and deci...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 2 years
While my unit was in warranty tech support replaced mine, I ...

In forum Hardware, firmware and software help

před 2 years
Happy to help, and that the problem is resolved. Personally ...

In forum Hardware, firmware and software help

před 2 years
Although this may not be it, I got bit by a intermittent fil...

In forum Hardware, firmware and software help

před 2 years
Great!

In forum Hardware, firmware and software help

před 2 years
Just a little more out of depth please, I only wish to relay...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 2 years
I've been experiencing a port error after installing the new...

In forum General discussion, announcements and releases

před 2 years
Following this post, I did the install and there's the start...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 2 years
If you paste the shutdown scripts, you can shut it down from...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 2 years
Stránka 1 / 10
Share: