|
"update" It looks like the filament accumulates at the nozzl... In forum How do I print this? (Printing help) |
4 years ago |
|
PETG Boogers In forum How do I print this? (Printing help) |
4 years ago |
|
Hey Jeff
Hey
How can I adjust the "multiple extrusion fact... In forum Assembly and first prints troubleshooting |
7 years ago |
|
Hey
How can I adjust the "multiple extrusion factor"
Do I ju... In forum Assembly and first prints troubleshooting |
7 years ago |
|
yes, it will not damage anything.
i tried even older firmw... In forum Assembly and first prints troubleshooting |
7 years ago |
|
hey,
yes, i noticed that the printer was in the wrong positi... In forum Assembly and first prints troubleshooting |
7 years ago |
|
hey the issue is still there. and i dont know what i can do.... In forum Assembly and first prints troubleshooting |
7 years ago |
|
hey
i can not open the link, so i dont see any image 🙂 In forum Prusa i3 kit (Archive) |
7 years ago |
|
it has the same value 4.2 In forum Assembly and first prints troubleshooting |
7 years ago |
|
okay , with proterface i can move both z axis 0.02mm (move z... In forum Assembly and first prints troubleshooting |
7 years ago |
|
here is a video of that issue. In forum Assembly and first prints troubleshooting |
7 years ago |
|
hey i only mesuered 4,2 ohm between red and blue. when the m... In forum Assembly and first prints troubleshooting |
7 years ago |
|
it is important that the motor are running/spinning? do they... In forum Assembly and first prints troubleshooting |
7 years ago |
|
Okay. I Will do that tomorrow. Now i am having some beers i... In forum Assembly and first prints troubleshooting |
7 years ago |
|
i fixed the wires.
but there is still that issue.
so i dont... In forum Assembly and first prints troubleshooting |
7 years ago |
|
it is possible that i destoryed little bit the wire
so that... In forum Assembly and first prints troubleshooting |
7 years ago |
|
did you saw this video?
he said that the print is misalign... In forum Prusa i3 kit (Archive) |
7 years ago |
|
When I printed the same model, I added supports, because the... In forum Prusa i3 kit (Archive) |
7 years ago |
|
calibartion issue, only the right z-axis motor is spinning, ... In forum Assembly and first prints troubleshooting |
7 years ago |
|
yes, when i calibrated the printer. the bed wasn't leveld. s... In forum Prusa i3 kit (Archive) |
7 years ago |
