Prusa3D Forum

Avisos

Vaciar todo

Omikron

Grupo: Registrado

Registrado: 2016/06/16

Estimable Member

	I've been traveling too much to be able to set up mine yet, ... En el foro Improvements (Archive)	hace 7 years
	Me again! Been trying to get back to tinkering with the stl ... En el foro Others (Archive)	hace 7 years
	Just go to an auto store and buy a sample or small bottle of... En el foro Prusa i3 kit (Archive)	hace 7 years
	Is anybody else seeing issue with retraction settings being ... En el foro General discussion, announcements and releases	hace 7 years
	It's not the easiest in the world to use (at least for me), ... En el foro Print tips (Archive)	hace 7 years
	Great work, Martin! I will definitely be adding this to my ... En el foro Improvements (Archive)	hace 7 years
	Thanks, I haven't tried ABS yet. I jumped from PLA to PETG ... En el foro Print tips (Archive)	hace 7 years
	Can't disagree on that. Which is why I use only my cheapest ... En el foro Others (Archive)	hace 7 years
	Perhaps this is a bit too obvious of a response to be what y... En el foro Print tips (Archive)	hace 7 years
	I think it might be useful if Prusa Research were to publish... En el foro Others (Archive)	hace 7 years
	I've had good experiences using torx screwdriver bits in lie... En el foro Others (Archive)	hace 7 years
	My printer has been idle for about a week now, because I jus... En el foro Print tips (Archive)	hace 7 years
	Interesting thought. I had never really considered that. I ... En el foro Print tips (Archive)	hace 7 years
	Delrin, the plastic that is used for the z-nut that goes on ... En el foro Prusa i3 kit (Archive)	hace 7 years
	Stepping on beads isn't so bad, one of those little paper ba... En el foro Print tips (Archive)	hace 7 years
	what do you mean with your z-axis calibration is reset? I'm... En el foro Prusa i3 kit (Archive)	hace 7 years
	To my knowledge such a thing does not exist but boy would it... En el foro Improvements (Archive)	hace 7 years
	WD-40 is quite good for flushing out contaminants and old gr... En el foro Others (Archive)	hace 7 years
	Thanks for the tip on the cases for the center of the spool.... En el foro Print tips (Archive)	hace 7 years
	... before packing it in an airtight bag with a silca gel cy... En el foro Print tips (Archive)	hace 7 years

Página 1 / 11 Siguiente

Estadísticas del Foro

535 Foros

59.5 K Temas

426.6 K Respuestas

16 En línea

63.9 K Miembros

Último Mensaje: Klipper config for Prusa MK3S/+ Nuestro miembro más reciente: Charles Jacques Últimos Mensajes Publicaciones sin leer Etiquetas

Iconos del foro: El foro no contiene publicaciones sin leer El foro contiene publicaciones sin leer

Iconos de los Temas: No respondidos Respondido Activo Popular Fijo No aprobados Resuelto Privado Cerrado