Prusa3D Forum

Benachrichtigungen

Alles löschen

Omikron

Gruppe: Registriert

Beigetreten: 2016/06/16

Estimable Member

	I've been traveling too much to be able to set up mine yet, ... Im Forum Improvements (Archive)	Vor 7 years
	Me again! Been trying to get back to tinkering with the stl ... Im Forum Others (Archive)	Vor 7 years
	Just go to an auto store and buy a sample or small bottle of... Im Forum Prusa i3 kit (Archive)	Vor 7 years
	Is anybody else seeing issue with retraction settings being ... Im Forum General discussion, announcements and releases	Vor 7 years
	It's not the easiest in the world to use (at least for me), ... Im Forum Print tips (Archive)	Vor 7 years
	Great work, Martin! I will definitely be adding this to my ... Im Forum Improvements (Archive)	Vor 7 years
	Thanks, I haven't tried ABS yet. I jumped from PLA to PETG ... Im Forum Print tips (Archive)	Vor 7 years
	Can't disagree on that. Which is why I use only my cheapest ... Im Forum Others (Archive)	Vor 7 years
	Perhaps this is a bit too obvious of a response to be what y... Im Forum Print tips (Archive)	Vor 7 years
	I think it might be useful if Prusa Research were to publish... Im Forum Others (Archive)	Vor 7 years
	I've had good experiences using torx screwdriver bits in lie... Im Forum Others (Archive)	Vor 7 years
	My printer has been idle for about a week now, because I jus... Im Forum Print tips (Archive)	Vor 7 years
	Interesting thought. I had never really considered that. I ... Im Forum Print tips (Archive)	Vor 7 years
	Delrin, the plastic that is used for the z-nut that goes on ... Im Forum Prusa i3 kit (Archive)	Vor 7 years
	Stepping on beads isn't so bad, one of those little paper ba... Im Forum Print tips (Archive)	Vor 7 years
	what do you mean with your z-axis calibration is reset? I'm... Im Forum Prusa i3 kit (Archive)	Vor 7 years
	To my knowledge such a thing does not exist but boy would it... Im Forum Improvements (Archive)	Vor 7 years
	WD-40 is quite good for flushing out contaminants and old gr... Im Forum Others (Archive)	Vor 7 years
	Thanks for the tip on the cases for the center of the spool.... Im Forum Print tips (Archive)	Vor 7 years
	... before packing it in an airtight bag with a silca gel cy... Im Forum Print tips (Archive)	Vor 7 years

Seite 1 / 11 Nächstes

Forums-Statistiken

535 Foren

59.5 K Themen

426.6 K Beiträge

16 Online

63.9 K Mitglieder

Letzter Beitrag: Buttons on Print Head Unser neuestes Mitglied: Charles Jacques Neueste Beiträge Ungelesene Beiträge Schlagwörter

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen