Activity
 
oliver
oliver
Group: Registered
Joined: 2019/12/22
Eminent Member
2
Same here... not working 😕 Is there a place where one can br...

In forum General discussion, announcements and releases

8 hours ago
@karl-herbert Interessanter mod der Y-Achse... habe etwas äh...

In forum Allgemeine Diskussion, Ankündigungen und Veröffentlichungen

10 hours ago
Hi, there is a long thread on this topic here: Prusa Mini : ...

In forum Assembly and first prints troubleshooting

2 months ago
@benji @crawlerin Tried it... did the M301 and saved it with...

In forum General discussion, announcements and releases

2 months ago
@sylvain-t2 Hi Sylvian, thanks again. Will look into that. R...

In forum Assembly and first prints troubleshooting

3 months ago
PID autotune... I didn't recall reading about the PID settin...

In forum General discussion, announcements and releases

3 months ago
Great post, tried it and it works great. Got the dimensions ...

In forum Assembly and first prints troubleshooting

3 months ago
It has been already discussed here and there is already an ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Unfortunately this does not work, if you have do do a filame...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
@briancotton4 😳 That's terrible... guess I was lucky 🙃

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
We have a 3D printer, right? That's what I've used M3 Wrench...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Well said, 👍🏻 from me too

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Maybe just changing the heat-break will help Bondtech Stainl...

In forum General discussion, announcements and releases

3 months ago
Hard to tell, because it was part of a bigger update: I've a...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
I've done it, look here:

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
Thanks for all the input. Bondtech updates arrived yesterday...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
@karl-herbert 🤔 Now I'm confused: If M500 stores the values,...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
Got new filament sensor today and installed it: working 👍🏻 S...

In forum Hardware, firmware and software help

4 months ago
Sure there are, look here Specific silicon socks for Mini

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
@omari Yeah, shipping from Bondtech, even to Germany is quit...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
Page 1 / 2
Share:

Please Login or Register