Activity
 
Olef
Olef
Group: Registered
Joined: 2017/06/21
Honorable Member
1
@crawlerin M3 x 6 will fit fine and will not interfere with ...

In forum General discussion, announcements and releases

8 hours ago
@andrew-p42 This is the exact problem I could foresee with t...

In forum General discussion, announcements and releases

8 hours ago
I have seen posted elsewhere the screw head should be flush ...

In forum General discussion, announcements and releases

2 days ago
@neophyl Mini does not have Bondtech gears...

In forum Assembly and first prints troubleshooting

4 days ago
Chat with support. That is not right. Looks like you may hav...

In forum Assembly and first prints troubleshooting

4 days ago
@connor-p-healy Thank you 🙂

In forum General discussion, announcements and releases

6 days ago
Can you link that test file please?

In forum General discussion, announcements and releases

6 days ago
Bad luck that, especially after waiting for it but any compo...

In forum Assembly and first prints troubleshooting

7 days ago
@lichtjaeger Just wanted to say thanks again for this. I fin...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 weeks ago
I'm just experiencing this for the first time. Ten hour prin...

In forum General discussion, announcements and releases

2 weeks ago
Wise words!

In forum General discussion, announcements and releases

2 weeks ago
No one can yet say how the Mini LAN functions will operate a...

In forum General discussion, announcements and releases

2 weeks ago
Sounds like you have things under control. Confirm I run sel...

In forum Assembly and first prints troubleshooting

2 weeks ago
Normal behaviour Jon. Mine heats hotend to 170 / 230 and bed...

In forum Assembly and first prints troubleshooting

2 weeks ago
@milehigh3der Unfortunately only two months late would be qu...

In forum General discussion, announcements and releases

2 weeks ago
@charles-h13 I tried this once too. You are right. It does n...

In forum General discussion, announcements and releases

2 weeks ago
So Who Has Broken Their 'Fuse' and is Compiling Their Own Fi...

In forum General discussion, announcements and releases

2 weeks ago
On the 4.0.1 firmware the LAN port was enabled and it picked...

In forum General discussion, announcements and releases

2 weeks ago
Look here -/p>

In forum Hardware, firmware and software help

3 weeks ago
(cross posted from the firmware thread) Looking at all the c...

In forum General discussion, announcements and releases

3 weeks ago
Page 1 / 35
Share:

Please Login or Register