Nomad965
Nomad965
Group: Registered
Joined: 2017/02/07
Trusted Member
3
Check the settings of the cooling fan see if they match the ...

In forum How do I print this? (Printing help)

4 months ago
Print a 35x35 sqaure thats only 0.2 thick and post back your...

In forum How do I print this? (Printing help)

4 months ago
Further testing this is the results, the Live Z adjusted as ...

In forum How do I print this? (Printing help)

4 months ago
File is 35x35 by 0.3 square thickness left is printed with d...

In forum How do I print this? (Printing help)

4 months ago
Okay yes, now I know where am getting things not right, misr...

In forum How do I print this? (Printing help)

4 months ago
Did some more testing on the subject and now noticing there ...

In forum How do I print this? (Printing help)

4 months ago
I am going to restest this one more time, but I am very sure...

In forum How do I print this? (Printing help)

4 months ago
I am not sure as to why, but in all honesty I used to do one...

In forum How do I print this? (Printing help)

4 months ago
RE: Overlap % VS Layer Height

In forum How do I print this? (Printing help)

5 months ago
RE: Overlap % VS Layer Height

In forum How do I print this? (Printing help)

5 months ago
Overlap % VS Layer Height

In forum How do I print this? (Printing help)

5 months ago
@neophyl Thank you for the feedback, I started using it a co...

In forum Hardware, firmware and software help

5 months ago
Good thing I asked, since most of the time am printing with ...

In forum Hardware, firmware and software help

5 months ago
I just noted something in the startup code under prusa slice...

In forum Hardware, firmware and software help

5 months ago
No different, so far so good, but I need to monitor a little...

In forum Hardware, firmware and software help

5 months ago
Also in regards to your scripts is it not better to have the...

In forum Hardware, firmware and software help

5 months ago
@bobstro Correct I did not find this in the configuration.h ...

In forum Hardware, firmware and software help

5 months ago
@bobstro On the following pagebr />Line 65 of your S3d scrip...

In forum Hardware, firmware and software help

5 months ago
Okay so, there is actually no need to reflash the firmware, ...

In forum Hardware, firmware and software help

5 months ago
Live Z adjustment, use a simple first layer test square 40x4...

In forum Hardware, firmware and software help

5 months ago
Page 1 / 5
Share:

Please Login or Register