nikolai.r
nikolai.r
Group: Registered
Joined: 2016/11/09
Noble Member
3
@bodo dxf for 2D and step for 3D are most common one and wid...

In forum General discussion, announcements and releases

41 mins ago
I'm glad to help you make decisions 🤣

In forum General discussion, announcements and releases

4 days ago
And I liked this tutorials for precision modelling in Blende...

In forum General discussion, announcements and releases

4 days ago
That's correct. Full parametric modelling is not really supp...

In forum General discussion, announcements and releases

4 days ago
@bobstro And no need to panic. Just be prepared. If that hap...

In forum General discussion, announcements and releases

4 days ago
For such big products profit is usually being generated by s...

In forum General discussion, announcements and releases

4 days ago
The thing in Fusion360 is that all projects are in the cloud...

In forum General discussion, announcements and releases

4 days ago
Thanks for the update. Time to get the projects exported the...

In forum General discussion, announcements and releases

4 days ago
Regular acrylic paint works fine for me. Especially on busts...

In forum General discussion, announcements and releases

1 week ago
Based on the estimate, yes:/p> Pure PETG is recommended beca...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 week ago
In this case the easiest approach is to swap the heater on y...

In forum Hardware, firmware and software help

1 week ago
Hi Peter, Best option is to buy the original replacement par...

In forum Hardware, firmware and software help

1 week ago
@dominikdrobny Die Drucktemperatur unterscheidet sich immer ...

In forum Sonstiges (Archiv)

1 week ago
@kamil-c Yes, PETG is stringy. It’s hard to avoid interventi...

In forum General discussion, announcements and releases

1 week ago
@kamil-c In general it’s the same approach you tune your oth...

In forum General discussion, announcements and releases

1 week ago
@warnings007 Upgrading MK2 to MK3(s) doesn't really make sen...

In forum General discussion, announcements and releases

2 weeks ago
One more hint in regards to that. If you print less then 5 c...

In forum Assembly and first prints troubleshooting

2 weeks ago
Good observation. 1. Check the FINDA, ball and the space whe...

In forum Assembly and first prints troubleshooting

2 weeks ago
PLA for gears is perfectly fine for the first version. You j...

In forum General discussion, announcements and releases

2 weeks ago
It highly depends on the root cause of the interventions yo...

In forum Assembly and first prints troubleshooting

2 weeks ago
Page 1 / 112
Share:

Please Login or Register