nikolai.r
nikolai.r
Group: Registered
Joined: 2016/11/09
Noble Member
3
I'm glad to help you make decisions 🤣

In forum General discussion, announcements and releases

2 days ago
And I liked this tutorials for precision modelling in Blende...

In forum General discussion, announcements and releases

2 days ago
That's correct. Full parametric modelling is not really supp...

In forum General discussion, announcements and releases

2 days ago
@bobstro And no need to panic. Just be prepared. If that hap...

In forum General discussion, announcements and releases

2 days ago
For such big products profit is usually being generated by s...

In forum General discussion, announcements and releases

2 days ago
The thing in Fusion360 is that all projects are in the cloud...

In forum General discussion, announcements and releases

2 days ago
Thanks for the update. Time to get the projects exported the...

In forum General discussion, announcements and releases

2 days ago
Regular acrylic paint works fine for me. Especially on busts...

In forum General discussion, announcements and releases

1 week ago
Based on the estimate, yes:/p> Pure PETG is recommended beca...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 week ago
In this case the easiest approach is to swap the heater on y...

In forum Hardware, firmware and software help

1 week ago
Hi Peter, Best option is to buy the original replacement par...

In forum Hardware, firmware and software help

1 week ago
@dominikdrobny Die Drucktemperatur unterscheidet sich immer ...

In forum Sonstiges (Archiv)

1 week ago
@kamil-c Yes, PETG is stringy. It’s hard to avoid interventi...

In forum General discussion, announcements and releases

1 week ago
@kamil-c In general it’s the same approach you tune your oth...

In forum General discussion, announcements and releases

1 week ago
@warnings007 Upgrading MK2 to MK3(s) doesn't really make sen...

In forum General discussion, announcements and releases

1 week ago
One more hint in regards to that. If you print less then 5 c...

In forum Assembly and first prints troubleshooting

1 week ago
Good observation. 1. Check the FINDA, ball and the space whe...

In forum Assembly and first prints troubleshooting

1 week ago
PLA for gears is perfectly fine for the first version. You j...

In forum General discussion, announcements and releases

1 week ago
It highly depends on the root cause of the interventions yo...

In forum Assembly and first prints troubleshooting

1 week ago
The retraction and insertion of the filament from MMU to the...

In forum Hardware, firmware and software help

1 week ago
Page 1 / 112
Share:

Please Login or Register