nikolai.r
nikolai.r
Group: Registered
Joined: 2016/11/09
Noble Member
3
Hi Peter, Best option is to buy the original replacement par...

In forum Hardware, firmware and software help

1 month ago
@dominikdrobny Die Drucktemperatur unterscheidet sich immer ...

In forum Sonstiges (Archiv)

1 month ago
@kamil-c Yes, PETG is stringy. It’s hard to avoid interventi...

In forum General discussion, announcements and releases

1 month ago
@kamil-c In general it’s the same approach you tune your oth...

In forum General discussion, announcements and releases

1 month ago
@warnings007 Upgrading MK2 to MK3(s) doesn't really make sen...

In forum General discussion, announcements and releases

1 month ago
One more hint in regards to that. If you print less then 5 c...

In forum Assembly and first prints troubleshooting

1 month ago
Good observation. 1. Check the FINDA, ball and the space whe...

In forum Assembly and first prints troubleshooting

1 month ago
PLA for gears is perfectly fine for the first version. You j...

In forum General discussion, announcements and releases

1 month ago
It highly depends on the root cause of the interventions yo...

In forum Assembly and first prints troubleshooting

1 month ago
The retraction and insertion of the filament from MMU to the...

In forum Hardware, firmware and software help

1 month ago
Yes, it requires some hardware. Beside the additional contro...

In forum General discussion, announcements and releases

1 month ago
As already mentioned here, it comes down to cooling performa...

In forum Hardware, firmware and software help

2 months ago
Honestly I wouldn't recommend any bowden printer to a newcom...

In forum Assembly and first prints troubleshooting

2 months ago
The term "quite" is pretty subjective. Of course to reduce t...

In forum Hardware, firmware and software help

2 months ago
That must be Springfield County Court House 🙂

In forum Awesome prints (Hall Of Fame)

2 months ago
As far as I remember the standard (on top) spool holder can ...

In forum General discussion, announcements and releases

2 months ago
Please don't get me wrong. But this sounds more like an issu...

In forum General discussion, announcements and releases

2 months ago
Just of curiosity. What kind of information have you request...

In forum General discussion, announcements and releases

2 months ago
Good decision to block prusaprinters.org. It's very addictiv...

In forum General discussion, announcements and releases

2 months ago
SpoolJoin function is pretty straight forward and works like...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
Page 3 / 114
Share:

Please Login or Register