nikolai.r
nikolai.r
Group: Registered
Joined: 2016/11/09
Noble Member
3
Zwischen 3.8.0 und 3.8.1 gab es keine nennenswerten Untersch...

In forum Allgemeine Diskussion, Ankündigungen und Veröffentlichungen

7 hours ago
@jeffk This are no printer specific settings. Speed looks go...

In forum How do I print this? (Printing help)

1 day ago
Hi Jeff, The designer already provided recommendations how t...

In forum How do I print this? (Printing help)

1 day ago
@nino-nobile Your issue is most likely a heat creep. With 0....

In forum How do I print this? (Printing help)

1 day ago
@noah-c3 Your hypothesis is correct. I print PC with 270C an...

In forum General discussion, announcements and releases

4 days ago
I think you can assume similar to E3Dv6, 24V heater. Maybe i...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 days ago
Mini takes regular E3D nozzles which are available in a wide...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 days ago
This one is easy to avoid by pausing only through Octoprint....

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 days ago
@james-m64 Sorry to hear that. Let PR replace the board or h...

In forum Hardware, firmware and software help

5 days ago
Please don't feed the troll.

In forum General discussion, announcements and releases

5 days ago
I think there are not many Minis in the wild right now. PR i...

In forum General discussion, announcements and releases

5 days ago
@wpegden I think it's easier to run a stable Octoprint inste...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 days ago
Looks like you've found already printable profile. It sticks...

In forum General discussion, announcements and releases

6 days ago
@caleb-clinkingbeard Login to Once done, you should see at t...

In forum Hardware, firmware and software help

6 days ago
Nothing prevents you to make such a thread. Just go for it a...

In forum General discussion, announcements and releases

6 days ago
@max-distortion Versicherungen sind immer so eine Sache fuer...

In forum Allgemeine Diskussion, Ankündigungen und Veröffentlichungen

7 days ago
Ob es von deiner Versicherung abgedeckt ist, solltest du mit...

In forum Allgemeine Diskussion, Ankündigungen und Veröffentlichungen

7 days ago
Seriously? Spec sheet is telling you 240-260C, people are te...

In forum How do I print this? (Printing help)

1 week ago
@acortelyou Most likely because it's not advised to run 280C...

In forum How do I print this? (Printing help)

1 week ago
@steve-4 Sure. With all the limitations like smaller print s...

In forum General discussion, announcements and releases

1 week ago
Page 1 / 101
Share:

Please Login or Register