|
I’ve started getting this blobbing again, possibly because I... In forum PrusaSlicer |
2 years ago |
|
Does anyone have trouble when doing filament change, when lo... In forum User mods - OctoPrint, enclosures, nozzles, ... |
3 years ago |
|
Thanks, for me I’m guessing the Mk3s firmware will be the op... In forum Hardware, firmware and software help |
3 years ago |
|
I’m trying to use the Mini Filament sensor for the MK3s, I c... In forum Hardware, firmware and software help |
3 years ago |
|
Using a Prusa Mini Filament Sensor on a Mk3s In forum Hardware, firmware and software help |
3 years ago |
|
Seems to show the prints having a matt finish, I just wash ... In forum General discussion, announcements and releases |
3 years ago |
|
Received mine today, did a Z level test with a 70mm square. ... In forum General discussion, announcements and releases |
3 years ago |
|
Received mine today, did a Z level test with a 70mm square. ... In forum General discussion, announcements and releases |
3 years ago |
|
Ah, you’re in America... they are a bit funny dealing with u... In forum General discussion, announcements and releases |
3 years ago |
|
Just checked, not in my spam.... what do you mean "next tier... In forum General discussion, announcements and releases |
3 years ago |
|
I didn’t get an email, I only noticed because you good guys ... In forum General discussion, announcements and releases |
3 years ago |
|
Does it say mk3s sheet on your invoice? Mine didn’t. Just pr... In forum General discussion, announcements and releases |
3 years ago |
|
For me thinking that I ordered the mini satin sheet, doesn’t... In forum General discussion, announcements and releases |
3 years ago |
|
I must be mad, £16 delivery to the uk,,, £55 total cost. I c... In forum General discussion, announcements and releases |
3 years ago |
|
I hoping the BuildTak will work better with ABS and ASA... l... In forum General discussion, announcements and releases |
3 years ago |
|
I’ve learnt to remove when the beds slightly warm and not be... In forum General discussion, announcements and releases |
3 years ago |
|
I agree, should be smooth as silk (satin) :). The textured d... In forum General discussion, announcements and releases |
3 years ago |
|
Impossible to purchase, I think the only people getting them... In forum General discussion, announcements and releases |
3 years ago |
|
Will they ever restock ? I’ve been looking since they became... In forum General discussion, announcements and releases |
3 years ago |
|
I thought this was the same as the Marlin Generator but twea... In forum Hardware, firmware and software help |
3 years ago |
