Notifications
Clear all
Nick-i3mk3s
Nick-i3mk3s
Group: Registered
Joined: 2019/05/30
Eminent Member
2
Update: I replaced the 74HC4050 level shifter chip on the bo...

In forum Hardware, firmware and software help

4 months ago
Unfortunately software (incl. firmware) updates are more oft...

In forum Hardware, firmware and software help

5 months ago
Already tried swapping the ribbon cables around, and didn't ...

In forum Hardware, firmware and software help

5 months ago
I've just upgraded the firmware of the printer to version 3....

In forum Hardware, firmware and software help

5 months ago
With no other suggestions, I've gone ahead and replaced the ...

In forum Hardware, firmware and software help

5 months ago
I know, my question was rather, how does changing the firmwa...

In forum Hardware, firmware and software help

6 months ago
Printing via USB works fine though, so wouldn't that suggest...

In forum Hardware, firmware and software help

6 months ago
That's something I hadn't thought about, I'll have a look at...

In forum Hardware, firmware and software help

6 months ago
I followed your advice to clean the pins internally with IPA...

In forum Hardware, firmware and software help

6 months ago
The pins look properly soldered on the outside, but had to l...

In forum Hardware, firmware and software help

6 months ago
@diem I tried the masking tape suggestion but as expected, i...

In forum Hardware, firmware and software help

6 months ago
I've tried multiple cards, including the original one, alway...

In forum Hardware, firmware and software help

6 months ago
Thanks for the reply @neophyl. I conducted a thorough visual...

In forum Hardware, firmware and software help

6 months ago
Unable to read SD cards

In forum Hardware, firmware and software help

1 year ago
@tim-m30 Point taken, Tim. However when I bought the Prusa M...

In forum Assembly and first prints troubleshooting

4 years ago
Update: it appears the collet that holds the PTFE tube in pl...

In forum Assembly and first prints troubleshooting

5 years ago
That's possible, because I had to apply a lot of force to th...

In forum Assembly and first prints troubleshooting

5 years ago
Tim, I just received the piece of PTFE tube from Ebay, and s...

In forum Assembly and first prints troubleshooting

5 years ago
Tim, are my survey answers: Printer: MK3S Material being pri...

In forum Assembly and first prints troubleshooting

5 years ago
The area above the blob is still 1.75 mm in diameter as meas...

In forum Assembly and first prints troubleshooting

5 years ago
Page 1 / 2
Share: