nicholas.m12
nicholas.m12
Group: Registered
Joined: 2018/08/24
Eminent Member
2
Mesh bed leveling is done at the start of every print. I usu...

In forum General discussion, announcements and releases

12 hours ago
This is a link to Prusa's model files. All of the pertinent ...

In forum Coronavirus (COVID-19)

15 hours ago
The surface finish from the textured sheet is great. I think...

In forum General discussion, announcements and releases

1 month ago
@hawwwran I cancelled my order a while ago but I am still fo...

In forum General discussion, announcements and releases

1 month ago
@fernwehmind It is possible to scratch the PEI surface if yo...

In forum Assembly and first prints troubleshooting

1 month ago
@chocki I agree with Chocki here. The textured sheet works g...

In forum General discussion, announcements and releases

1 month ago
There is risk to it. There is risk inherent in all of your e...

In forum General discussion, announcements and releases

1 month ago
@jweaver I had wondered about getting different filaments to...

In forum General discussion, announcements and releases

2 months ago
@crawlerin Really? Good news!

In forum How do I print this? (Printing help)

2 months ago
@robert-rmm200 I have never used them but like the idea of h...

In forum Hardware, firmware and software help

2 months ago
@acortelyou It's not necessarily unable to print nylon. It's...

In forum How do I print this? (Printing help)

2 months ago
@neil-t I do the same. My thinking is that the PEI will wear...

In forum General discussion, announcements and releases

2 months ago
@gnat It seems this company is making an honest attempt to r...

In forum General discussion, announcements and releases

2 months ago
I would not worry about setting up the raspberry pi. If you ...

In forum General discussion, announcements and releases

3 months ago
@p-voet Yes. It's a common dish soap in the US. I have seen ...

In forum How do I print this? (Printing help)

3 months ago
I have a speculative idea in regards to the filament sensor;...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
@emperorofthedaleks66 This seems like a reasonable request t...

In forum General discussion, announcements and releases

3 months ago
@bobstro The term "pre-order" seems to confuse a lot of peo...

In forum General discussion, announcements and releases

3 months ago
@sembazuru I think this may be what he was referencing: I t...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
I just wanted to chime in and say I appreciate y’all taking ...

In forum General discussion, announcements and releases

4 months ago
Page 1 / 2
Share:

Please Login or Register