Notifications
Clear all
NibMaker
NibMaker
Group: Registered
Joined: 2020/02/29
Eminent Member
2
@sylvain-t2 Exactly the same issue I ran into with the same ...

In forum General discussion, announcements and releases

4 years ago
@oliver Oooo! That seems like a neat solution! Hmm...I might...

In forum General discussion, announcements and releases

4 years ago
@strigusconsilium I've had my Mini for about two months now ...

In forum General discussion, announcements and releases

4 years ago
Thanks for the design @lichtjaeger ! Pictures:/p> I've been ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
I'm 99% sure when you auto-home and move your hotend like th...

In forum Assembly and first prints troubleshooting

4 years ago
Like Holger mentioned, do a cold/atomic pull with the PTFE l...

In forum Assembly and first prints troubleshooting

4 years ago
@benji Hey! I want to confirm, do you still have drifting Z-...

In forum Assembly and first prints troubleshooting

4 years ago
@oxygen Were you able to resolve this? I'm having the same i...

In forum Assembly and first prints troubleshooting

4 years ago
I've only had one roll of fairly old PLA clog and gum up my ...

In forum Assembly and first prints troubleshooting

4 years ago
When I'm impatient and don't want to touch the build surface...

In forum Assembly and first prints troubleshooting

4 years ago
@atomleef PETG & flexibles really likes to stick to PEI ...

In forum Assembly and first prints troubleshooting

4 years ago
You don't need to use a tool to remove prints from the Mini'...

In forum Assembly and first prints troubleshooting

4 years ago
My ideal Z-offset for the textured sheet is around -1.080mm,...

In forum Assembly and first prints troubleshooting

4 years ago
Successfully upgraded to 4.0.4 and reprinted my calibration ...

In forum General discussion, announcements and releases

4 years ago
@jakub-d @texy 4.0.4 fixed it! Thanks so much for the aweso...

In forum Assembly and first prints troubleshooting

4 years ago
I also had issues getting PETG to stick to my textured build...

In forum Hardware, firmware and software help

4 years ago
This was the best diagram I found when I was searching the o...

In forum Hardware, firmware and software help

4 years ago
@dahuafschmied Well noted! I downgraded back to 4.0.2 and th...

In forum Assembly and first prints troubleshooting

4 years ago
@dahuafschmied My Mini arrived with 4.0.2 installed, but I'v...

In forum Assembly and first prints troubleshooting

4 years ago
Sanity check on Prusa Mini noises while printing.

In forum Assembly and first prints troubleshooting

4 years ago
Share: