Neophyl
Neophyl
Group: Registered
Joined: 2018/10/23
Noble Member
3
This is mainly a user to user forum. While the devs do occa...

In forum PrusaSlicer

1 week ago
Not using Prusa Slicer no. That capability is part of Super ...

In forum How do I print this? (Printing help)

1 week ago
I think the forum was playing up. When I first looked the 3...

In forum PrusaSlicer

1 week ago
Does it really matter if that is what it takes to print ? I...

In forum PrusaSlicer

1 week ago
@jsw Yes I guess we wont ever agree 🙂 Stick around here lo...

In forum Assembly and first prints troubleshooting

1 week ago
Manually. That's pretty much it. Figuring out what setting...

In forum PrusaSlicer

1 week ago
With insufficient infill what you are in effect doing is pri...

In forum How do I print this? (Printing help)

1 week ago
If thats the top surface of your part then its a combination...

In forum How do I print this? (Printing help)

1 week ago
In answer to the original question, no it is not possible.

In forum PrusaSlicer

1 week ago
I've seen the cura fuzzy skin used on a replacement hacksaw ...

In forum How do I print this? (Printing help)

1 week ago
I suspected as such. One of the bugfixes put into firmware ...

In forum General discussion, announcements and releases

1 week ago
You can use an image in software like blender to apply a 'bu...

In forum How do I print this? (Printing help)

1 week ago
You arent pressing the x button to start a print are you ? ...

In forum General discussion, announcements and releases

1 week ago
What version firmware is your printer running ?

In forum General discussion, announcements and releases

2 weeks ago
JSW that attached test stl file has the following issues -9...

In forum PrusaSlicer

2 weeks ago
Normally when installing you run through the configuration w...

In forum PrusaSlicer

2 weeks ago
When things dont slice due to being too small you have a few...

In forum PrusaSlicer

2 weeks ago
Thingiverse is full of broken/partial working models. The f...

In forum PrusaSlicer

2 weeks ago
Firstly if you go to the preview screen pictured you can cha...

In forum PrusaSlicer

2 weeks ago
If you have access to a resin printer then that is what they...

In forum PrusaSlicer

2 weeks ago
Page 3 / 81
Share:

Please Login or Register