Neophyl
Neophyl
Group: Registered
Joined: 2018/10/23
Honorable Member
1
Assuming you are using Prusa slicer save your project as.......

In forum Hardware, firmware and software help

1 day ago
Best way to ‘fix’ this is to fit a sock, they are relatively...

In forum Hardware, firmware and software help

1 day ago
It’s hard to tell with that translucent filament. When you p...

In forum Assembly and first prints troubleshooting

1 day ago
Creating watertight casings even for industrial products is ...

In forum General discussion, announcements and releases

1 day ago
There are already so many identical ones raised about it and...

In forum PrusaSlicer

1 day ago
It was specifically designed that way. There’s a long conver...

In forum PrusaSlicer

1 day ago
I think you will need to ask over on GitHub, I suspect the c...

In forum Assembly and first prints troubleshooting

1 day ago
Is the benchy from the sd card files pre-sliced by Prusa ?

In forum Assembly and first prints troubleshooting

1 day ago
The batman logo shows the infill isnt reaching the perimeter...

In forum Assembly and first prints troubleshooting

1 day ago
Forgive me if you know any of this already but .... Thats a...

In forum Hardware, firmware and software help

1 day ago
The latest version is 2.2.0. You can always check on the la...

In forum PrusaSlicer

2 days ago
OK now this has me stumped. I cant see anything unusual wit...

In forum Assembly and first prints troubleshooting

2 days ago
What do you mean by not follow the contours ? Your little ...

In forum PrusaSlicer

2 days ago
Save your project as (saves as a .3mf) and zip it up and att...

In forum Assembly and first prints troubleshooting

2 days ago
If they arent squished into a solid unbroken sheet then your...

In forum Assembly and first prints troubleshooting

2 days ago
Just had a look at what the MK3 uses for machine limits on Z...

In forum PrusaSlicer

2 days ago
Inside the bearing are LOTS of tiny steel ball bearings. Th...

In forum Hardware, firmware and software help

2 days ago
If your normal layers are over extruding have you calibrated...

In forum PrusaSlicer

2 days ago
Please read and yes making your custom printer inherit and ...

In forum PrusaSlicer

2 days ago
Thanks, didnt know about that. If you do find the parameters...

In forum PrusaSlicer

2 days ago
Page 2 / 38
Share:

Please Login or Register