Neophyl
Neophyl
Group: Registered
Joined: 2018/10/23
Honorable Member
1
Is the benchy from the sd card files pre-sliced by Prusa ?

In forum Assembly and first prints troubleshooting

3 hours ago
The batman logo shows the infill isnt reaching the perimeter...

In forum Assembly and first prints troubleshooting

3 hours ago
Forgive me if you know any of this already but .... Thats a...

In forum Hardware, firmware and software help

6 hours ago
The latest version is 2.2.0. You can always check on the la...

In forum PrusaSlicer

6 hours ago
OK now this has me stumped. I cant see anything unusual wit...

In forum Assembly and first prints troubleshooting

6 hours ago
What do you mean by not follow the contours ? Your little ...

In forum PrusaSlicer

7 hours ago
Save your project as (saves as a .3mf) and zip it up and att...

In forum Assembly and first prints troubleshooting

7 hours ago
If they arent squished into a solid unbroken sheet then your...

In forum Assembly and first prints troubleshooting

11 hours ago
Just had a look at what the MK3 uses for machine limits on Z...

In forum PrusaSlicer

12 hours ago
Inside the bearing are LOTS of tiny steel ball bearings. Th...

In forum Hardware, firmware and software help

12 hours ago
If your normal layers are over extruding have you calibrated...

In forum PrusaSlicer

12 hours ago
Please read and yes making your custom printer inherit and ...

In forum PrusaSlicer

20 hours ago
Thanks, didnt know about that. If you do find the parameters...

In forum PrusaSlicer

21 hours ago
When you take them off be sure to properly lubricate the ins...

In forum Hardware, firmware and software help

21 hours ago
You could disable the lines in the start gcode for mesh leve...

In forum How do I print this? (Printing help)

22 hours ago
Its been awhile since I built a mk3s but is it possible that...

In forum Hardware, firmware and software help

22 hours ago
Do you have anything besides your computer on a network ? T...

In forum PrusaSlicer

22 hours ago
The 'end stop' positions on all the axis are determined by t...

In forum Hardware, firmware and software help

22 hours ago
Missed the edit timer window so .... What exactly is the iss...

In forum PrusaSlicer

23 hours ago
Did you set the infill speed too in the modifier ? Could yo...

In forum PrusaSlicer

23 hours ago
Page 1 / 36
Share:

Please Login or Register