Neophyl
Neophyl
Group: Registered
Joined: 2018/10/23
Honorable Member
1
Go to the printer selection tab, select the printer profile ...

In forum Hardware, firmware and software help

15 mins ago
Assuming you are using Prusa slicer save your project as.......

In forum Hardware, firmware and software help

17 mins ago
Best way to ‘fix’ this is to fit a sock, they are relatively...

In forum Hardware, firmware and software help

21 mins ago
It’s hard to tell with that translucent filament. When you p...

In forum Assembly and first prints troubleshooting

27 mins ago
Creating watertight casings even for industrial products is ...

In forum General discussion, announcements and releases

30 mins ago
There are already so many identical ones raised about it and...

In forum PrusaSlicer

35 mins ago
It was specifically designed that way. There’s a long conver...

In forum PrusaSlicer

46 mins ago
I think you will need to ask over on GitHub, I suspect the c...

In forum Assembly and first prints troubleshooting

52 mins ago
Is the benchy from the sd card files pre-sliced by Prusa ?

In forum Assembly and first prints troubleshooting

5 hours ago
The batman logo shows the infill isnt reaching the perimeter...

In forum Assembly and first prints troubleshooting

5 hours ago
Forgive me if you know any of this already but .... Thats a...

In forum Hardware, firmware and software help

7 hours ago
The latest version is 2.2.0. You can always check on the la...

In forum PrusaSlicer

8 hours ago
OK now this has me stumped. I cant see anything unusual wit...

In forum Assembly and first prints troubleshooting

8 hours ago
What do you mean by not follow the contours ? Your little ...

In forum PrusaSlicer

8 hours ago
Save your project as (saves as a .3mf) and zip it up and att...

In forum Assembly and first prints troubleshooting

9 hours ago
If they arent squished into a solid unbroken sheet then your...

In forum Assembly and first prints troubleshooting

12 hours ago
Just had a look at what the MK3 uses for machine limits on Z...

In forum PrusaSlicer

13 hours ago
Inside the bearing are LOTS of tiny steel ball bearings. Th...

In forum Hardware, firmware and software help

13 hours ago
If your normal layers are over extruding have you calibrated...

In forum PrusaSlicer

14 hours ago
Please read and yes making your custom printer inherit and ...

In forum PrusaSlicer

22 hours ago
Page 1 / 37
Share:

Please Login or Register