Neophyl
Neophyl
Group: Registered
Joined: 2018/10/23
Noble Member
3
You could also be suffering from a partial clog. Or have yo...

In forum Hardware, firmware and software help

2 hours ago
@jack Yes, I have used it several times on actual prints. M...

In forum How do I print this? (Printing help)

2 hours ago
There were a lot of user issues with fields changing back ar...

In forum General discussion, announcements and releases

6 hours ago
When you slice a object look through the various options on ...

In forum Assembly and first prints troubleshooting

16 hours ago
Several factors if you are using Prusa Slicer. Firstly is ...

In forum Assembly and first prints troubleshooting

17 hours ago
I can tell you now that both of these issues (multiple times...

In forum PrusaSlicer

23 hours ago
Its very likely to be an incorrect model. The fact it had t...

In forum Hardware, firmware and software help

23 hours ago
I downloaded it and placed it and it fit with the default pl...

In forum General discussion, announcements and releases

23 hours ago
The confirm 0 by hitting enter is a known issue in slicer. H...

In forum General discussion, announcements and releases

2 days ago
Prusa Slicer doesnt no. Is your pressure advance anything li...

In forum PrusaSlicer

3 days ago
If you can loosen the wrap off somewhat, untwist it. IIRC t...

In forum Assembly and first prints troubleshooting

3 days ago
I'm in the UK. My normal day job is software test engineer ...

In forum How do I print this? (Printing help)

3 days ago
I did a bit of experimenting. That G1 Z0.100 F7800.000 is t...

In forum PrusaSlicer

3 days ago
Nice example. Both slicers are slicing it as a section of s...

In forum PrusaSlicer

3 days ago
It should only be a few lines needed. Ok, what temperatures ...

In forum Hardware, firmware and software help

4 days ago
There is. If you have a Prusa printer such as a MK3 or a Mi...

In forum PrusaSlicer

4 days ago
Yes by adjusting your extrusion width it can get rid of the ...

In forum PrusaSlicer

4 days ago
The values in Prusa Slicers defaults are in there as thats w...

In forum Print tips (Archive)

4 days ago
Simple answer is yes.It depends on what the material is and ...

In forum General discussion, announcements and releases

4 days ago
Any advice without the requested information is just guesses...

In forum How do I print this? (Printing help)

4 days ago
Page 1 / 62
Share:

Please Login or Register