|
V nejnověším FW 6.0.0-RC1 (Release Candidate): nedávno přib... In forum Obecná diskuze, oznámení a novinky |
2 weeks ago |
|
Taky bych zkusil odvětrávání, jestli uvnitř není už moc hork... In forum Hardware, firmware a software (Pomoc) |
2 weeks ago |
|
This one is on the PCB (LoveBoard):/p>
so just look for a ... In forum General discussion, announcements and releases |
3 months ago |
|
Schematic has been released for MK4:/p> In forum Hardware, firmware and software help |
3 months ago |
|
Zkusil bych forum od Creality In forum Obecná diskuze, oznámení a novinky |
5 months ago |
|
It is located on the Buddy main board. In forum Hardware, firmware and software help |
5 months ago |
|
Vše lze sdílet už celkem dlouho v rámci Printables (.STL/.gc... In forum PrusaSlicer |
6 months ago |
|
Belts must be tune pretty well for Input Shaper:/p> In forum Input Shaper (MINI) |
7 months ago |
|
Yes, some of ppl with Revo confirmed that it works pretty we... In forum Input Shaper (MINI) |
7 months ago |
|
Mrkni na verzi Firmware a případně aktualizuj, FW s češtinou... In forum Hardware, firmware a software (Pomoc) |
7 months ago |
|
Mimochodem, od včerejška se už začly posílat 🙂 In forum Obecná diskuze, oznámení a novinky |
7 months ago |
|
Ono to vyjde finančně i časově lépe než plný upgrade. In forum Obecná diskuze, oznámení a novinky |
7 months ago |
|
Hi guys, as the slow WiF is the most criticized drawback of ... In forum Hardware, firmware and software help |
8 months ago |
|
Maybe it is a good idea provide a feedback to Prusa Chat Sup... In forum Assembly and first prints troubleshooting |
8 months ago |
|
Kalibrace je automatická: In forum Obecná diskuze, oznámení a novinky |
8 months ago |
|
PM (Plasty Mladeč) In forum Nejlepší výtisky & tiskové tipy |
8 months ago |
|
Marlin 2 In forum Hardware, firmware a software (Pomoc) |
8 months ago |
|
There are LED labels at the back of the LoveBoard PCB. Just ... In forum Hardware, firmware and software help |
9 months ago |
|
I bought one of first 100 MK4 and it is more polished than M... In forum Hardware, firmware and software help |
9 months ago |
|
OK, switch back to English:EMC problems are always a layout ... In forum Assembly and first prints troubleshooting |
9 months ago |
