Activity
 
Marty
Marty
Group: Registered
Joined: 2020/03/25
Eminent Member
2
Got them done, wired up, and working:

In forum Awesome prints (Hall Of Fame)

1 week ago
You want to check that when you extrude 100 mm, 100 mm of fi...

In forum Assembly and first prints troubleshooting

1 week ago
Flight Sim Rudder pedals with toe breaks.

In forum Awesome prints (Hall Of Fame)

1 week ago
I was just thinking the same thing, could be bad for anyone ...

In forum General discussion, announcements and releases

1 week ago
It's pretty rare for a 3D printer to catch fire, but it has ...

In forum General discussion, announcements and releases

1 week ago
@jsw I can answer for the RHD CS nozzle shroud. For that on...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
I've also been using the RHD CS nozzle shroud on Thingiverse...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
@karl-herbert Yes, the hands require supports since they cur...

In forum Awesome prints (Hall Of Fame)

2 months ago
Duchamp chess set

In forum Awesome prints (Hall Of Fame)

3 months ago
I've been using the black Buildtak sheets on my cobbled toge...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
If you print something like a 20mm cube and measure all side...

In forum Hardware, firmware and software help

4 months ago
Is the bed heating OK? If it is then the copper traces on t...

In forum Hardware, firmware and software help

4 months ago
Yeah, if all the hardware checks out it might be a firmware ...

In forum Hardware, firmware and software help

4 months ago
@alec Sorry, yes, the heads of those screws do stop the Z ax...

In forum Hardware, firmware and software help

4 months ago
It seems to be searching OK in Z and X, only question remain...

In forum Hardware, firmware and software help

4 months ago
Did you check if the probe is being detected? In the menu g...

In forum Hardware, firmware and software help

4 months ago
That is a tough one, if something was lose you would expect ...

In forum General discussion, announcements and releases

4 months ago
Just search for "decal paper" and you'll find lots of them. ...

In forum Awesome prints (Hall Of Fame)

4 months ago
@sw3de Thanks. They are water slide decals, brand I used is ...

In forum Awesome prints (Hall Of Fame)

4 months ago
Decided to spend a little more time on this thing and finish...

In forum Awesome prints (Hall Of Fame)

4 months ago
Page 1 / 3
Share:

Please Login or Register