|
One or two heads? I just received the email that I can final... In forum Assembly and first prints troubleshooting |
8 months ago |
|
Yep, I saw that yesterday. Doesn't look bad at all, but ther... In forum Assembly and first prints troubleshooting |
11 months ago |
|
They talked about this on the live stream today. Their own p... In forum Assembly and first prints troubleshooting |
11 months ago |
|
I sent them an email asking, and I got the feedback that the... In forum Assembly and first prints troubleshooting |
1 year ago |
|
I would guess that Prusa has a pretty good idea of the avera... In forum Assembly and first prints troubleshooting |
1 year ago |
|
If it really is in the vicinity of 3-5 hours, then great. It... In forum Assembly and first prints troubleshooting |
1 year ago |
|
Semi-assembled version - time to build? In forum Assembly and first prints troubleshooting |
1 year ago |
|
The printer dimensions are 80x80 cm according to the product... In forum General discussion, announcements and releases |
2 years ago |
|
Yes, good point. I managed to miss that in my excitement! In forum General discussion, announcements and releases |
2 years ago |
|
There will be high demand, so I secured a place in the queue... In forum General discussion, announcements and releases |
2 years ago |
|
@zemso You can choose the new "Snug" support type style to s... In forum PrusaSlicer |
2 years ago |
|
@zemso It seems to be mostly down to support material, where... In forum PrusaSlicer |
2 years ago |
|
So I tested the test build, and I can confirm I am getting t... In forum PrusaSlicer |
2 years ago |
|
I also did not get any message about PS wanting to send Syst... In forum PrusaSlicer |
2 years ago |
|
Correction: You don't need to add a second extruder. A range... In forum PrusaSlicer |
3 years ago |
|
The issue at the bottom can be worked around by adding a sec... In forum PrusaSlicer |
3 years ago |
|
I've been looking for the same thing, but I haven't found it... In forum PrusaSlicer |
3 years ago |
|
I know, and this exact issue has been discussed over there a... In forum PrusaSlicer |
5 years ago |
|
And for the most part I am using another slicer, but as I've... In forum PrusaSlicer |
5 years ago |
|
And because of that you think it is OK that the slicer has c... In forum PrusaSlicer |
5 years ago |
