Activity
 
MrMik
MrMik
Group: Registered
Joined: 2016/09/21
Honorable Member
1
I used high quality PLA. But the stiffness and resistance a...

In forum Awesome prints (Hall Of Fame)

11 months ago
Reset button did not change the issue. 3rd consecutive print...

In forum Hardware, firmware and software help

11 months ago
G-Whale-7 fin now fully functional

In forum Awesome prints (Hall Of Fame)

11 months ago
I have now pressed the reset button on the controller and am...

In forum Hardware, firmware and software help

11 months ago
I3 MK3 randomly stops during printing

In forum Hardware, firmware and software help

11 months ago
Thank you, Neal and Robin! I used even more brute force and...

In forum Hardware, firmware and software help

2 years ago
Unable to remove heatsink out of MK3 extruder

In forum Hardware, firmware and software help

2 years ago
A new heater element will not fix the problem. I would pro...

In forum Hardware, firmware and software help

2 years ago
Thanks for your help, and may your cables always be of suffi...

In forum Hardware, firmware and software help

2 years ago
Strange that they have a 4 pin connector on the board and in...

In forum Hardware, firmware and software help

2 years ago
Where did you measure the EINSY output voltage? I stuck so...

In forum Hardware, firmware and software help

2 years ago
Is your PINDA connected like this, and does it not respond i...

In forum Hardware, firmware and software help

2 years ago
I have seen this problem a few times when using an older Sli...

In forum How do I print this? (Printing help)

2 years ago
Sometimes this is cause by the PTFE tube not fully inserted ...

In forum Hardware, firmware and software help

2 years ago
I think you need to dis-assemble the extruder and replace th...

In forum Hardware, firmware and software help

2 years ago
Where did you measure the EINSY output voltage?

In forum Hardware, firmware and software help

2 years ago
Pinda connector with 4 pins instead of 3 ???

In forum Hardware, firmware and software help

2 years ago
Along the same line of question: What is the meaning of the...

In forum General discussion, announcements and releases

2 years ago
> sudo apt-get autoremove modemmanager We have requested...

In forum General discussion, announcements and releases

2 years ago
I think this should help you to allow access to the serial l...

In forum General discussion, announcements and releases

2 years ago
Page 1 / 31
Share:

Please Login or Register