Activity
 
MrMik
MrMik
Group: Registered
Joined: 2016/09/21
Honorable Member
1
I used high quality PLA. But the stiffness and resistance a...

In forum Awesome prints (Hall Of Fame)

9 months ago
Reset button did not change the issue. 3rd consecutive print...

In forum Hardware, firmware and software help

9 months ago
G-Whale-7 fin now fully functional

In forum Awesome prints (Hall Of Fame)

9 months ago
I have now pressed the reset button on the controller and am...

In forum Hardware, firmware and software help

9 months ago
I3 MK3 randomly stops during printing

In forum Hardware, firmware and software help

9 months ago
Thank you, Neal and Robin! I used even more brute force and...

In forum Hardware, firmware and software help

2 years ago
Unable to remove heatsink out of MK3 extruder

In forum Hardware, firmware and software help

2 years ago
A new heater element will not fix the problem. I would pro...

In forum Hardware, firmware and software help

2 years ago
Thanks for your help, and may your cables always be of suffi...

In forum Hardware, firmware and software help

2 years ago
Strange that they have a 4 pin connector on the board and in...

In forum Hardware, firmware and software help

2 years ago
Where did you measure the EINSY output voltage? I stuck so...

In forum Hardware, firmware and software help

2 years ago
Is your PINDA connected like this, and does it not respond i...

In forum Hardware, firmware and software help

2 years ago
I have seen this problem a few times when using an older Sli...

In forum How do I print this? (Printing help)

2 years ago
Sometimes this is cause by the PTFE tube not fully inserted ...

In forum Hardware, firmware and software help

2 years ago
I think you need to dis-assemble the extruder and replace th...

In forum Hardware, firmware and software help

2 years ago
Where did you measure the EINSY output voltage?

In forum Hardware, firmware and software help

2 years ago
Pinda connector with 4 pins instead of 3 ???

In forum Hardware, firmware and software help

2 years ago
Along the same line of question: What is the meaning of the...

In forum General discussion, announcements and releases

2 years ago
> sudo apt-get autoremove modemmanager We have requested...

In forum General discussion, announcements and releases

2 years ago
I think this should help you to allow access to the serial l...

In forum General discussion, announcements and releases

2 years ago
Page 1 / 31
Share:

Please Login or Register