Activity
 
Notifications
Clear all
MrMik
MrMik
Group: Registered
Joined: 2016/09/21
Honorable Member
1
Is your PINDA connected like this, and does it not respond i...

In forum Hardware, firmware and software help

6 years ago
I have seen this problem a few times when using an older Sli...

In forum How do I print this? (Printing help)

6 years ago
Sometimes this is cause by the PTFE tube not fully inserted ...

In forum Hardware, firmware and software help

6 years ago
I think you need to dis-assemble the extruder and replace th...

In forum Hardware, firmware and software help

6 years ago
Where did you measure the EINSY output voltage?

In forum Hardware, firmware and software help

6 years ago
Pinda connector with 4 pins instead of 3 ???

In forum Hardware, firmware and software help

6 years ago
Along the same line of question: What is the meaning of the...

In forum General discussion, announcements and releases

6 years ago
> sudo apt-get autoremove modemmanager We have requested...

In forum General discussion, announcements and releases

6 years ago
I think this should help you to allow access to the serial l...

In forum General discussion, announcements and releases

6 years ago
UPDATE: The final version of Slic3r PE 1.40.0 is out! Downl...

In forum General discussion, announcements and releases

6 years ago
I am using Swiss clips to hold a steel sheet to my mk2 prin...

In forum Hardware, firmware and software help

6 years ago
Thanks Chris and Joan! Those Swiss Clips look great, if the...

In forum Hardware, firmware and software help

6 years ago
Attaching spring steel more firmly?

In forum Hardware, firmware and software help

6 years ago
> Is there a way to turn on the 'Slice now' button when o...

In forum General discussion, announcements and releases

6 years ago
Any chance to make a "somewhat less flex plate"? My prints ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
Heat wear degradation on a silicon sock??? 😮 Certainly, i...

In forum General discussion, announcements and releases

6 years ago
> avrdude: ser_open(): can't open device "/dev/ttyACM0": ...

In forum General discussion, announcements and releases

6 years ago
Thank you Joan and John, I found it in the Start g-code: M2...

In forum Assembly and first prints troubleshooting

6 years ago
Flow tuning [persistent

In forum Assembly and first prints troubleshooting

6 years ago
0.35 mm was replaced with 0.2 mm profile as it brings better...

In forum General discussion, announcements and releases

6 years ago
Page 2 / 31
Share: