Activity
 
Notifications
Clear all
MrMik
MrMik
Group: Registered
Joined: 2016/09/21
Honorable Member
1
Cheers, that works very well!

In forum Hardware, firmware and software help

12 months ago
The part is 242mm wide, the photo shows how the skirt ends u...

In forum Hardware, firmware and software help

12 months ago
Prusa i3 MK3 not printing centred the middle of the printbed

In forum Hardware, firmware and software help

12 months ago
So I can just start each program with $fn=150; _min = 0.01; ...

In forum PrusaSlicer

1 year ago
Thanks, I was indeed using the 2019 version for some reason....

In forum PrusaSlicer

1 year ago
Thank you for the explanation, that worked. I did not use th...

In forum PrusaSlicer

1 year ago
I don't know it OpenScad is causing the issue. The older S...

In forum PrusaSlicer

1 year ago
Thank you, Neophyl! I already solved the problem by upgradin...

In forum PrusaSlicer

1 year ago
Slic3r playing up - putting non-existent layers in

In forum PrusaSlicer

1 year ago
I used high quality PLA. But the stiffness and resistance a...

In forum Awesome prints (Hall Of Fame)

5 years ago
Reset button did not change the issue. 3rd consecutive print...

In forum Hardware, firmware and software help

5 years ago
G-Whale-7 fin now fully functional

In forum Awesome prints (Hall Of Fame)

5 years ago
I have now pressed the reset button on the controller and am...

In forum Hardware, firmware and software help

5 years ago
I3 MK3 randomly stops during printing

In forum Hardware, firmware and software help

5 years ago
Thank you, Neal and Robin! I used even more brute force and...

In forum Hardware, firmware and software help

6 years ago
Unable to remove heatsink out of MK3 extruder

In forum Hardware, firmware and software help

6 years ago
A new heater element will not fix the problem. I would pro...

In forum Hardware, firmware and software help

6 years ago
Thanks for your help, and may your cables always be of suffi...

In forum Hardware, firmware and software help

6 years ago
Strange that they have a 4 pin connector on the board and in...

In forum Hardware, firmware and software help

6 years ago
Where did you measure the EINSY output voltage? I stuck so...

In forum Hardware, firmware and software help

6 years ago
Page 1 / 31
Share: