|
Cheers, that works very well! In forum Hardware, firmware and software help |
1 year ago |
|
The part is 242mm wide, the photo shows how the skirt ends u... In forum Hardware, firmware and software help |
1 year ago |
|
Prusa i3 MK3 not printing centred the middle of the printbed In forum Hardware, firmware and software help |
1 year ago |
|
So I can just start each program with $fn=150; _min = 0.01; ... In forum PrusaSlicer |
1 year ago |
|
Thanks, I was indeed using the 2019 version for some reason.... In forum PrusaSlicer |
1 year ago |
|
Thank you for the explanation, that worked. I did not use th... In forum PrusaSlicer |
1 year ago |
|
I don't know it OpenScad is causing the issue.
The older S... In forum PrusaSlicer |
1 year ago |
|
Thank you, Neophyl! I already solved the problem by upgradin... In forum PrusaSlicer |
1 year ago |
|
Slic3r playing up - putting non-existent layers in In forum PrusaSlicer |
1 year ago |
|
I used high quality PLA. But the stiffness and resistance a... In forum Awesome prints (Hall Of Fame) |
5 years ago |
|
Reset button did not change the issue. 3rd consecutive print... In forum Hardware, firmware and software help |
5 years ago |
|
G-Whale-7 fin now fully functional In forum Awesome prints (Hall Of Fame) |
5 years ago |
|
I have now pressed the reset button on the controller and am... In forum Hardware, firmware and software help |
5 years ago |
|
I3 MK3 randomly stops during printing In forum Hardware, firmware and software help |
5 years ago |
|
Thank you, Neal and Robin!
I used even more brute force and... In forum Hardware, firmware and software help |
6 years ago |
|
Unable to remove heatsink out of MK3 extruder In forum Hardware, firmware and software help |
6 years ago |
|
A new heater element will not fix the problem.
I would pro... In forum Hardware, firmware and software help |
6 years ago |
|
Thanks for your help, and may your cables always be of suffi... In forum Hardware, firmware and software help |
6 years ago |
|
Strange that they have a 4 pin connector on the board and in... In forum Hardware, firmware and software help |
6 years ago |
|
Where did you measure the EINSY output voltage?
I stuck so... In forum Hardware, firmware and software help |
6 years ago |
