|
Just for anyone finding this thread on the MK2, I just solve... In forum Prusa i3 kit (Archive) |
7 years ago |
|
So this mentions upgrading your smooth rods, but after sear... In forum General discussion, announcements and releases |
7 years ago |
|
I love PETG as well, was kind of shocked at how few profiles... In forum Others (Archive) |
7 years ago |
|
I had lots of issues with jamming when I first got the kit. ... In forum Others (Archive) |
7 years ago |
|
Welp, Ninjaflex is definitely a no go. Which sucks because I... In forum Others (Archive) |
7 years ago |
|
The multi material slic3r is different from direct drive. MM... In forum Others (Archive) |
7 years ago |
|
Soluble Support Not Touching Model In forum Others (Archive) |
7 years ago |
|
Check support extrusion width under advanced. For some reaso... In forum Print tips (Archive) |
7 years ago |
|
I followed the README instructions and am still getting this... In forum Others (Archive) |
7 years ago |
|
I'm genuinely thrilled to know that flex isn't being written... In forum Others (Archive) |
7 years ago |
|
Removing the idler helped too. In forum Others (Archive) |
7 years ago |
|
I had success using an xacto knife, some pliers and a little... In forum Others (Archive) |
7 years ago |
|
Is there an alternative to Limonene? It is expensive the onl... In forum Hardware, firmware and software help |
7 years ago |
|
My guess would be a very loose belt, or the motor gear loose... In forum Others (Archive) |
7 years ago |
|
You can also use a soldering iron or lighter to patch spots ... In forum Others (Archive) |
7 years ago |
|
FYSA, the issue was the extruder motor cable was damaged and... In forum Awesome prints (Hall Of Fame) |
7 years ago |
|
Right behind the x axis bearings. One of the zip ties was th... In forum Others (Archive) |
7 years ago |
|
I just print at regular pla settings and sand off the string... In forum Others (Archive) |
7 years ago |
|
Check to see if the threaded rods that connect to the prusa ... In forum Others (Archive) |
7 years ago |
|
Hi guys, I printed this castle for the first time at 70% spe... In forum Others (Archive) |
7 years ago |
