michael.c31
michael.c31
Group: Registered
Joined: 2017/08/06
Eminent Member
2
so as a follow up to this it appears that the problem was th...

In forum Assembly and first prints troubleshooting

1 year ago
sorry about these not being on the build plate. It kind of g...

In forum Hardware, firmware and software help

1 year ago
Layer Shifts

In forum Hardware, firmware and software help

1 year ago
Update: No more jamming on my extruder after replacing MK2.5...

In forum Assembly and first prints troubleshooting

1 year ago
my mistake. i was referring to the PTFE tube that sits in th...

In forum Assembly and first prints troubleshooting

1 year ago
There are various work-arounds for this already posted here....

In forum Assembly and first prints troubleshooting

1 year ago
so nice update. the PTFE tube ended up getting stretched out...

In forum Assembly and first prints troubleshooting

1 year ago
it failed again with a tip that measures at 2.03mm ramming a...

In forum Assembly and first prints troubleshooting

2 years ago
it failed again with a tip that measures at 2.03mm ramming a...

In forum Assembly and first prints troubleshooting

2 years ago
it seemed to help with stringy tips at normal / suggested pr...

In forum Assembly and first prints troubleshooting

2 years ago
started another print and red had a problem right off the ba...

In forum Assembly and first prints troubleshooting

2 years ago
started another print and red had a problem right off the ba...

In forum Assembly and first prints troubleshooting

2 years ago
i am wondering about going back a a 2.0mm hot end tube. Ar...

In forum Assembly and first prints troubleshooting

2 years ago
getting stuck in the PTFE tube in the hotend is a symptom an...

In forum Assembly and first prints troubleshooting

2 years ago
getting stuck in the PTFE tube in the hotend is a symptom an...

In forum Assembly and first prints troubleshooting

2 years ago
the green was not in use it was the white filament. and i ha...

In forum Assembly and first prints troubleshooting

2 years ago
The green one look pretty bad for PLA. Try with lower temp o...

In forum Assembly and first prints troubleshooting

2 years ago
the filament i am using is inland PLA. and the tips measure ...

In forum Assembly and first prints troubleshooting

2 years ago
i am going to high jack this post as i think i am in the sam...

In forum Assembly and first prints troubleshooting

2 years ago
The extruder motor current was set to a rather high value (3...

In forum Hardware, firmware and software help

2 years ago
Page 1 / 2
Share:

Please Login or Register