mgruenloh
mgruenloh
Group: Registered
Joined: 2020/05/11
Eminent Member
2
Atomic filament nuclear nylon issue

In forum How do I print this? (Printing help)

2 months ago
@krishanuar The Midwest nozzle is 100% tungsten. The thermal...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
I real think @jsw said it best in his post “From your photo,...

In forum General discussion, announcements and releases

2 months ago
@charles-h13 It may be great material, if you don’t wind gr...

In forum General discussion, announcements and releases

2 months ago
I should have looked closer at the images of this filament o...

In forum General discussion, announcements and releases

2 months ago
@charles-h13 I don’t think I’ll give up on them, but for a f...

In forum General discussion, announcements and releases

2 months ago
@3dprintingscience I love the CoPA. What I didn’t like was t...

In forum General discussion, announcements and releases

2 months ago
@peter-m26 Thank you for the advice Peter. The issue is NOT...

In forum General discussion, announcements and releases

2 months ago
@jsw Physically it's kind of like a TPU, a little soft, yet ...

In forum General discussion, announcements and releases

2 months ago
Kodak Filament

In forum General discussion, announcements and releases

2 months ago
Extrusion curls and blobs on filament load

In forum Assembly and first prints troubleshooting

2 months ago
@bobstro Just out of curiousity, why not the Pro sock? That ...

In forum Hardware, firmware and software help

2 months ago
I've learned, through experience, that particular fan cooli...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
@andrewld There shouldn’t be an issue having the in use spoo...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
I use a 44 quart Iris tub. It sits on a shelf unit sitting n...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
@matthew-c35 I haven't used IPA yet. I use dish soap and wat...

In forum General discussion, announcements and releases

3 months ago
@matthew-c35 What do you clean the plate with?

In forum General discussion, announcements and releases

3 months ago
@charles-h13 I'll keep an eye on that, mine is a little over...

In forum General discussion, announcements and releases

3 months ago
@charles-h13 and @matthew-c35 I have to admit that I haven't...

In forum General discussion, announcements and releases

3 months ago
@aigaiorcb I think 100C for 4 hours is too much heat for to ...

In forum How do I print this? (Printing help)

3 months ago
Page 1 / 3
Share:

Please Login or Register