Notifications
Clear all
metacollin
metacollin
Group: Registered
Joined: 2017/09/22
Eminent Member
2
Of course, if you were to use a dedicated external reference...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
This isn't strictly true. The ATMEGA 2560 has a SAR (succes...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
GUIDE: How to get water and airtight prints on the first try...

In forum General discussion, announcements and releases

5 years ago
Titanium has a much lower thermal conductivity than the stee...

In forum Hardware, firmware and software help

5 years ago
I'm coming pretty late to this game, but do you need any mor...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
Which one should we get if: A) we plan to use the original h...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
MK3 Volcano Mod

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
or is it the 12v? It seems that e3D may only sell the 24v v...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
where are the files from the first post?

In forum Others (Archive)

6 years ago
You have a couple of options. The more complex and dangerou...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
OK, so I can't believe this even worked... I feel like there...

In forum Hardware, firmware and software help

6 years ago
But is there some replacement command to M907 to quickly tes...

In forum Hardware, firmware and software help

6 years ago
For the motors i went with 2A per coil OSM Motors. 17HS16-2...

In forum Hardware, firmware and software help

6 years ago
Hi, so I just discovered this thread, I'll be perfectly hone...

In forum Hardware, firmware and software help

6 years ago
we're already at the limit of the 30Watt heater cartridge in...

In forum Improvements (Archive)

6 years ago
Hi, sorry about bumping an older thread. There isn't any pr...

In forum Others (Archive)

6 years ago
There is a much easier way to remove prints from the print b...

In forum Print tips (Archive)

6 years ago
So I recently ran into this same problem, and Peter has it r...

In forum Others (Archive)

6 years ago
Hi, after some revisions and testing, I think it's ready for...

In forum Improvements (Archive)

6 years ago
I hope you don't mind john.w18, but I decided to design a fr...

In forum Improvements (Archive)

6 years ago
Page 1 / 2
Share: