Notifications
Clear all
MechLink
MechLink
Group: Registered
Joined: 2016/11/21
Estimable Member
4
I am having the same issue with mine, it has been printing ...

In forum Hardware, firmware and software help

4 years ago
I have my PC next to my printer and I have always had issues...

In forum General discussion, announcements and releases

5 years ago
Well then then the only thing I can suggest is doing a proce...

In forum Assembly and first prints troubleshooting

5 years ago
Ya I find that the cheaper filaments dont do so well in the ...

In forum Assembly and first prints troubleshooting

5 years ago
Try running a print in single mode and use extruder 4 and se...

In forum Assembly and first prints troubleshooting

5 years ago
have you checked to see if the set screw on the extruder mot...

In forum Assembly and first prints troubleshooting

5 years ago
I use these all the time with really good results PLA: Fi...

In forum General discussion, announcements and releases

5 years ago
awesome job

In forum Awesome prints (Hall Of Fame)

5 years ago
looks good

In forum Awesome prints (Hall Of Fame)

5 years ago
very nice

In forum Awesome prints (Hall Of Fame)

5 years ago
scary 😀 good job

In forum Awesome prints (Hall Of Fame)

5 years ago
great job

In forum Awesome prints (Hall Of Fame)

5 years ago
looks good

In forum Awesome prints (Hall Of Fame)

5 years ago
Love the new setup and features. The only Issue I am having...

In forum General discussion, announcements and releases

5 years ago
looks good

In forum Awesome prints (Hall Of Fame)

5 years ago
These are the belts I replaced mine with, Its been nearly 2...

In forum General discussion, announcements and releases

6 years ago
bump

In forum Hardware, firmware and software help

6 years ago
looks good

In forum Awesome prints (Hall Of Fame)

6 years ago
Issue with Slic3r PE v1.41.0

In forum Hardware, firmware and software help

6 years ago
I would contact Prusa on this either via email or via the on...

In forum General discussion, announcements and releases

6 years ago
Page 2 / 10
Share: