|
@bobstro For me it was a kit build but I've had it for awhil... In forum How do I print this? (Printing help) |
4 years ago |
|
I am starting to suspect the controller issue as well. It d... In forum How do I print this? (Printing help) |
4 years ago |
|
I got 3.9R firmware, same issue, it wouldn't even go thru s... In forum How do I print this? (Printing help) |
4 years ago |
|
@mdaneman SD, it's been all over the place for me ever since... In forum How do I print this? (Printing help) |
4 years ago |
|
@mdaneman SD, it's been all over the place for me ever since... In forum How do I print this? (Printing help) |
4 years ago |
|
@mdaneman SD it's been all over the place for me ever since ... In forum How do I print this? (Printing help) |
4 years ago |
|
Thank you. I have 3.8.1 Is 3.9 RC on github ? In forum How do I print this? (Printing help) |
4 years ago |
|
Thanks a lot let me try doing this. It is interesting that ... In forum How do I print this? (Printing help) |
4 years ago |
|
Weird Layer issue shift on this model. In forum How do I print this? (Printing help) |
4 years ago |
|
So in my case it was as I suspected a motor. When I unplugg... In forum Hardware, firmware and software help |
4 years ago |
|
The bearings and rods are greased nicely. It's really the m... In forum Hardware, firmware and software help |
4 years ago |
|
Weird X axis issues. In forum Hardware, firmware and software help |
4 years ago |
|
@tim-m30 Thanks, let me see if I can reset it. I tripple ch... In forum Hardware, firmware and software help |
4 years ago |
|
X axis calibration error after flashing firmware In forum Hardware, firmware and software help |
4 years ago |
|
Were you able to fit enclosure cover that goes over the term... In forum User mods - OctoPrint, enclosures, nozzles, ... |
5 years ago |
