martin.d17
martin.d17
Group: Registered
Joined: 2017/08/30
Trusted Member
3
Nope no rumble, just crash occured, I checket the printed su...

In forum Hardware, firmware and software help

1 month ago
Y Crash detected 12 times during single print :O

In forum Hardware, firmware and software help

1 month ago
I dont really understand this.

In forum Assembly and first prints troubleshooting

3 months ago
@peter-m26 Thanks Peter for your help, I have 3 prusa printe...

In forum Assembly and first prints troubleshooting

3 months ago
Thanks for the tip, this is the lowest Z I can have otherwis...

In forum Assembly and first prints troubleshooting

3 months ago
Strange pattern on first layer (new MK3S)

In forum Assembly and first prints troubleshooting

3 months ago
Found the issue. The extruder drive gear was not properly ti...

In forum Hardware, firmware and software help

3 months ago
I am using Plasty Plasty Mladec filament, should have the sa...

In forum Hardware, firmware and software help

3 months ago
Stringing, and looks like uneven walls on Mini

In forum Hardware, firmware and software help

3 months ago
Thank you Neophyl! I missed that option, even I was looking ...

In forum PrusaSlicer

3 months ago
PrusaSlicer bridging direction setup?

In forum PrusaSlicer

3 months ago
Thank you very much!

In forum Hardware, firmware and software help

4 months ago
Prusa Mini and ESP-01(S) module - installation

In forum Hardware, firmware and software help

4 months ago
@alain-corchia Comparing 3.5k printer with 1k does not make ...

In forum General discussion, announcements and releases

4 months ago
do you have laser thermometer? Please try to print eg Prusa ...

In forum General discussion, announcements and releases

4 months ago
@towlerg They send me coupon I think, so I bought some spare...

In forum General discussion, announcements and releases

4 months ago
Any plans for new version of MMU2S - I am about to purchase ...

In forum General discussion, announcements and releases

4 months ago
@unknwnrider Do you mean the M500 makes change of M92 perman...

In forum Hardware, firmware and software help

5 months ago
Thank you guys! I will use the Gcode yet. Hopefully in futur...

In forum Hardware, firmware and software help

5 months ago
Bondtech MINI dual drive upgrade - help with firmware - z ca...

In forum Hardware, firmware and software help

5 months ago
Page 1 / 3
Share:

Please Login or Register