|
@neophyl Thank you for your fast answer. Concerning the firm... In forum Hardware, firmware and software help |
3 years ago |
|
@john-h57 Maybe you can try this one: Just installer the sp... In forum Hardware, firmware and software help |
3 years ago |
|
Remark: Printer is i3 MK3S Firmware 3.9.1-3518 In forum Hardware, firmware and software help |
3 years ago |
|
Filament change using M600 / Filament extrusion before resta... In forum Hardware, firmware and software help |
3 years ago |
|
Sorry, just forget the initial issue: The assembly of the sp... In forum Hardware, firmware and software help |
4 years ago |
|
@caroleedwards Installing the filament spool holder shouldn´... In forum Hardware, firmware and software help |
4 years ago |
|
Hello Caroleedwards, maybe you can specify your problem a li... In forum Hardware, firmware and software help |
4 years ago |
|
@charles-h13 Then you´re one of these who had luck 🙂 Mine s... In forum Hardware, firmware and software help |
4 years ago |
|
At daylight I had an closer look on the steel sheet - even i... In forum Hardware, firmware and software help |
4 years ago |
|
Still struggling what exactly do you wanna do? Unload the PL... In forum Hardware, firmware and software help |
4 years ago |
|
I first used an protective vanish for electronic components-... In forum Hardware, firmware and software help |
4 years ago |
|
No there is no sharp burr around the hole, so it´s more stra... In forum Hardware, firmware and software help |
4 years ago |
|
Heatbed damaged by spring steel sheet In forum Hardware, firmware and software help |
4 years ago |
|
Had the same problem, found the solution here: Also created... In forum Assembly and first prints troubleshooting |
4 years ago |
|
@masterhead Thanx - I had the same problem with a new printe... In forum Assembly and first prints troubleshooting |
4 years ago |
