Activity
 
Mark
Mark
Group: Registered
Joined: 2020/04/24
Eminent Member
2
Could it be Y carriage related? Are the rods and U bolts ok?

In forum Assembly and first prints troubleshooting

1 month ago
I also use 21030.

In forum Hardware, firmware and software help

4 months ago
Concerning packing without a printed tool - you can squeeze ...

In forum Hardware, firmware and software help

4 months ago
In theory 7x7 is better. However it takes longer... so if yo...

In forum How do I print this? (Printing help)

4 months ago
@chrisdmd The Mk3s is using 9 point by default, using a 3x3 ...

In forum How do I print this? (Printing help)

4 months ago
This might be by design. If your printer is printing from SD...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
Also, are the magnets install the correct way and can the li...

In forum Assembly and first prints troubleshooting

4 months ago
Quiet is very subjective. I wish Prusa would put a video up ...

In forum General discussion, announcements and releases

4 months ago
Mine on stealth is louder too. I think it’s down to the reso...

In forum General discussion, announcements and releases

4 months ago
Sounds normal - or at least it sounds the same as mine. If I...

In forum General discussion, announcements and releases

4 months ago
Great article - cheers.

In forum General discussion, announcements and releases

5 months ago
Adjusting speed on the printer

In forum General discussion, announcements and releases

5 months ago
They sell Prusament (made in house) and other filament that ...

In forum General discussion, announcements and releases

5 months ago
Great idea about using an SPL meter! Whilst not a proper met...

In forum Hardware, firmware and software help

5 months ago
I’ve seen a fair few posts about the noise level of these pr...

In forum Hardware, firmware and software help

5 months ago
There is no way I could sleep in the same room that my print...

In forum Hardware, firmware and software help

5 months ago
When it’s moving fast it’s always going to make a noise as t...

In forum Hardware, firmware and software help

5 months ago
I’d also source some IPA and some 683 bearings to use with a...

In forum General discussion, announcements and releases

5 months ago
So you clean with IPA a before each print? Perhaps wash with...

In forum General discussion, announcements and releases

5 months ago
Mine sounds the same. When you hear people say it’s really q...

In forum Hardware, firmware and software help

5 months ago
Page 1 / 3
Share:

Please Login or Register