manelto
manelto
Group: Registered
Joined: 2017/09/20
Estimable Member
4
very funny. I like very much.

In forum Awesome prints (Hall Of Fame)

11 months ago
For i can see, perhaps the rods are not aligned.

In forum Hardware, firmware and software help

11 months ago
I think it's the fan configuration. In any case, for now the...

In forum Hardware, firmware and software help

11 months ago
Well, I've only tried the Benchy and it went pretty good. Th...

In forum Hardware, firmware and software help

11 months ago
Now I have much better impressions with eSUN ePA CF. I bough...

In forum Hardware, firmware and software help

11 months ago
Please don't get me wrong. I think your solution is very goo...

In forum General discussion, announcements and releases

11 months ago
@karl-herbert-g Perfect! That is wonderful but I already ass...

In forum General discussion, announcements and releases

11 months ago
For me, it would be great to be able to change the preheatin...

In forum General discussion, announcements and releases

11 months ago
Jajajaja! That is what prevents me from doing it to me.

In forum General discussion, announcements and releases

11 months ago
Oh, yes! you're right. And precisily the new firmware has th...

In forum General discussion, announcements and releases

11 months ago
RE: Firmware 3.8.0-FINAL for Original Prusa i3 MK3S & MK3

In forum General discussion, announcements and releases

11 months ago
Thanks for do it!

In forum General discussion, announcements and releases

11 months ago
Well, perhaps there's not a problem with stability 😊

In forum General discussion, announcements and releases

11 months ago
I like the new Mini Prusa but I have certain doubts and I wo...

In forum General discussion, announcements and releases

11 months ago
lower the pinda a little and try again

In forum Hardware, firmware and software help

11 months ago
More than a couple of years ago I bought the MK2 and after a...

In forum Assembly and first prints troubleshooting

11 months ago
I had this problem with a chinese MK52 and I could't resolve...

In forum Assembly and first prints troubleshooting

11 months ago
I'm tempted with the mini too. I have an MK3S with the Bear ...

In forum General discussion, announcements and releases

11 months ago
I have those two filaments (petg + CF and Nylon +CF). But I ...

In forum Hardware, firmware and software help

11 months ago
+1

In forum General discussion, announcements and releases

11 months ago
Page 3 / 6
Share:

Please Login or Register