malcmcm
malcmcm
Group: Registered
Joined: 2020/07/18
Trusted Member
3
Only happens in 4.1 onwards and doesn't happen when printing...

In forum Assembly and first prints troubleshooting

2 months ago
Hardened steel nozzles don't have the same thermal propertie...

In forum How do I print this? (Printing help)

2 months ago
As bobstro mentioned, this is not the expected behavior, it ...

In forum Assembly and first prints troubleshooting

2 months ago
Also post your STL, I will test it out

In forum General discussion, announcements and releases

2 months ago
Have you tried modifying the 'extra length on restart' might...

In forum General discussion, announcements and releases

2 months ago
strange post print behaviour is known to happen with 4.1+ fi...

In forum General discussion, announcements and releases

2 months ago
@loglow Someone has done this successfully, it requires you ...

In forum Hardware, firmware and software help

2 months ago
@vital-g I've had the same experience (2 min warmup) but wou...

In forum Hardware, firmware and software help

2 months ago
Mine sounds the same, sounds worse at high speeds and repeti...

In forum Hardware, firmware and software help

2 months ago
Sorry I can't help you with volumetric flow but there is a p...

In forum PrusaSlicer

3 months ago
Oh and to answer your specific question in F360, select the ...

In forum How do I print this? (Printing help)

3 months ago
Fusion 360 is very easy and intuitive once you understand a ...

In forum How do I print this? (Printing help)

3 months ago
For small surface areas prints, especially ones that are als...

In forum Assembly and first prints troubleshooting

3 months ago
Hmm, I'm using the latest version 1.4.2, what is the plug-in...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
@towlerg What is your setup? Have you done it with a Mini? I...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Ok found out what was causing it to make that noise, had som...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Has anyone taped or blocked their 5v pin on the USB? I'm get...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Looks like on your second layer, the nozzle is hitting high...

In forum Hardware, firmware and software help

3 months ago
@neophyl Good to know! But also, if it has the possibility o...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Also if you're in the US, McMaster has loads of options for ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Page 1 / 4
Share:

Please Login or Register