|
Really?
Thats not the feeling I'm getting, its more of a 'r... In forum General discussion, announcements and releases |
6 years ago |
|
Spoke too soon.
Well I'm back to square one again. Managed ... In forum Assembly and first prints troubleshooting |
6 years ago |
|
So, today...
Yesterday the printer wasn't going to print an... In forum Assembly and first prints troubleshooting |
6 years ago |
|
I was wondering what people would think about a poll thread?... In forum Hardware, firmware and software help |
6 years ago |
|
TLDR;
My heat break was bent, as far as I can remember it w... In forum Assembly and first prints troubleshooting |
6 years ago |
|
Peter,
Please be around here... 😉
Problem located. He... In forum Assembly and first prints troubleshooting |
6 years ago |
|
Tomorrow morning I will get my Octoprint RPi out connect it ... In forum Assembly and first prints troubleshooting |
6 years ago |
|
OK, let's simplify things a bit.
Slice a model and print. ... In forum Assembly and first prints troubleshooting |
6 years ago |
|
Just about prints with a single filament, the intermittamt g... In forum Assembly and first prints troubleshooting |
6 years ago |
|
OK, the fun continues....
First off my z-height at 790 was o... In forum Assembly and first prints troubleshooting |
6 years ago |
|
OK, the fun continues....
I have replaced the filaments now... In forum Assembly and first prints troubleshooting |
6 years ago |
|
[/quote]
Best thing to do is to print the temperature test c... In forum Assembly and first prints troubleshooting |
6 years ago |
|
So.....
I have replaced the Heatbreak and the heater block ... In forum Assembly and first prints troubleshooting |
6 years ago |
|
So now I'm at the point where I need to vent.
Well, sorry ... In forum Assembly and first prints troubleshooting |
6 years ago |
|
I don't have that much time to get this working, well I do b... In forum Assembly and first prints troubleshooting |
6 years ago |
|
So now I'm at the point where I need to vent. I have the MMU... In forum Assembly and first prints troubleshooting |
6 years ago |
|
I asked and I was given....
Shipping Helpers. In forum Prusa i3 kit (Archive) |
7 years ago |
|
Hey,
I wanted them too and if fact I have been using them.... In forum Prusa i3 kit (Archive) |
7 years ago |
|
Sure, just edit the Prusa Marlin Firmware and upload it to t... In forum Prusa i3 kit (Archive) |
7 years ago |
|
It looks like the RepRapFullgraphics display. I have a simil... In forum Prusa i3 kit (Archive) |
7 years ago |
